Hearth and Home Technologies SFE-MKLB3530PP manual Electrical Wiring, Service Instructions

4 Electrical Wiring

X1

	Lamp		Interlock on
Projector			Media Cabinet only
	S7			Remote Receiver
		M
	Motor
			P1		Flame
			Power Supply Module		Heat

RD

Hot Line

Ground

Neutral

Branch Circuit

							Flame
				Terminal Strip			4050-309
						ON	Wall Switch
				1
							Heat
NEMA-5IEC 320 C13/C14 12 VOC						WH
	Power	J1			RD	WH
				5
	Supply
				Ember Bed & Back Log			4050-310
				R2			Wall Thermostat
				LED LED LED
			D1	R1
Heater	Hi Limit			LED LED LED
				Heat Indicator
Heater-Blower

M

Motor

5 Service Instructions

WARNING! Disconnect power at circuit breaker before at- tempting any maintenance or cleaning to reduce the risk of fire, electrical shock or personal injury.

A. Replacing the Light Bulb

This appliance uses a single 12 Volt, 35 Watt, MR-16 bulb. The bulb is located behind the smoke shield.

A spare is provided with the unit. Replacement bulbs (Part No. 4050-123) are available through your Simplifyre dealer.

•Turn off power to the unit at the main service panel.

•Let the fireplace cool if it has been operating.

•Release the spring pins and remove the upper shield.

•Remove the two screws on the projector basket.

•Rotate the housing down to access the bulb.

•Remove the screws holding the bulb and socket.

•Unplug the bulb from the socket.

•Replace the bulb.

•Re-assemble in the reverse order.

B. Screen Cleaning

During shipment, installation, handling, etc., the screen surface may collect dust particles; these can be removed by lightly wiping with a clean, dry cloth.

C. Maintenance of Motors

The motors used on the fan and flame projector assembly are pre-lubricated for extended bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater unit is recommended.

D. Resetting the Temperature Cutout Switch

The heater on this fireplace is protected with a safety device to prevent overheating. Should the heater overheat, an automatic cutout will turn OFF the heater/blower. The switch is reset by turning the unit OFF, waiting 10-15 minutes and switching the unit back ON.

7 Hearth & Home Technologies Inc. • Plug & Play • 4050-317 Rev A • 04/08