Hearth and Home Technologies E42 Maintenance Instructions, Disposal of Ashes, Creosote and Soot

Page 29

E36/39/42 INSTALLATION INSTRUCTIONS

I. MAINTENANCE INSTRUCTIONS

1. Disposal of Ashes

Ashes should be placed in a metal container with a tight-fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, well away from all combustible materials, pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all embers have thoroughly cooled.

WARNING!

A chimney fire can permanently damage your chim- ney system. This damage can only be repaired by replacing the damaged component parts. Chimney fires are not covered by the Limited Warranty and Buyer Protection Plan.

2. Creosote and Soot

Inspect the chimney internally for obstructions and construction damage. Flue pipe joints and seams must be continuous and mechanical tight. In a used chimney, additional inspection is needed for creosote buildup, which is the formation of a flammable sediment.

When wood is burned slowly, it produces tar and other organic vapors, which combine with expelled moisture to form creosote. The creosote vapors condense in the relatively cool chimney flue of a slow-burning fire. As a result, creosote residue accumulates on the flue lining. When ignited, this creosote makes an extremely hot fire.

The chimney should be inspected at least twice a year during the heating season to determine if creosote buildup has occurred.

If creosote has accumulated, it should be removed to reduce the risk of a chimney fire.

3. Chimney Cleaning

If you do detect a buildup of creosote, contact a qualified chimney sweep or clean it yourself. To do this, perform the following steps:

a.Open the damper.

b.Hang a damp sheet across the fireplace opening to stop dirt and soot from entering the room.

c.Remove the termination cap or housing top. See Figure 28.

d.Clean with a stiff nylon brush attached to a pole OR tie a small burlap bag filled with straw and several small stones or sand. Work up and down the flue until the flue is clean.

e.Replace the termination cap or housing top.

4. Clear Space Near the Fireplace

Combustible materials must not be stored on the hearth extension. Room furnishings such as drapes, curtains, chairs, or other combustibles must be at least four feet from the open front of the fireplace.

Figure 28 - Chimney & Termination Cap Cleaning

08/04

17335 Rev L

29

Image 29
Contents Woodburning Fireplace Installation & Operating InstructionsTable of Contents Design and Installation Considerations Description of the Fireplace System Listings and Code ApprovalsFireplace Components System ComponentsOutside AIR KIT CAK4A Chimney ComponentsAS8 CAK4A Fireplace Locations and Space Requirements PRE-INSTALLATION PreparationFraming the Fireplace Frame the FireplaceSidewalls/Surrounds Chimney RequirementsOffset Chart Using Offsets and ReturnsNumber of Sections Required Chimney Height Requirements above roof linePosition the Fireplace Installation of FireplacePlace the Protective Metal Hearth Strips Level the FireplaceAssemble Chimney Sections Install Firestop SpacersSecure the Chimney System Double-check the Chimney AssemblyAttic Insulation Shield Install the Outside Air Kit Install the Roof FlashingInstall the Chimney Air Kit required in Canada Mark the Exit Point of the RoofGas Log/Lighter Provisions Completion of the EnclosureField Constructed Hearth Extension Hearth ExtensionFinishing Material Position the Hearth ExtensionMantel Glass DoorsMaterials Constructing a ChaseTermination Cap Chase TopInstalling an ST375 Square Termination Cap General Information Operating InstructionsOutside Air Flue DamperWood Fuel GrateFirescreen Starting a Fire Draft ProblemsE36/39/42 Installation Instructions Chimney Cleaning Maintenance InstructionsDisposal of Ashes Creosote and SootHOMEOWNER’S Notes Index Limited Warranty Heatilator Woodburning Fireplace Limited WarrantyReplacement Parts Advantage How to Obtain Service