Hearth and Home Technologies PIER-TRC, R-CORNER-TRC Introducing the Heat-N-Glo Gas Fireplaces

Page 13

Getting Started

Introducing the Heat-N-Glo Gas Fireplaces

Heat-N-Glo direct vent gas fireplaces are designed to oper- ate with all combustion air siphoned from outside of the building and all exhaust gases expelled to the outside.

The information contained in this Installers Guide, unless noted otherwise, applies to all models and gas control systems. Gas fireplace diagrams, including the dimensions, are shown in this section.

Pre-install Preparation

This gas fireplace and its components are tested and safe when installed in accordance with this Installers Guide. Report to your dealer any parts damaged in shipment, particularly the condition of the glass. Do not install any unit with damaged, incomplete, or substitute parts.

The vent system components are shipped in separate pack- ages. The gas logs are packaged separately and must be field installed.

Read all of the instructions before starting the instal- lation. Follow these instructions carefully during the installation to ensure maximum safety and benefit. Failure to follow these instructions will void the own- er’s warranty and may present a fire hazard.

The Heat-N-Glo Warranty will be voided by, and Heat-N-Glo disclaims any responsibility for, the following actions:

•Installation of any damaged fireplace or vent system component.

•Modification of the fireplace or direct vent system.

•Installation other than as instructed by Heat-N-Glo.

•Improper positioning of the gas logs or the glass door.

•Installation and/or use of any component part not manu- factured and approved by Heat-N-Glo, not withstanding any independent testing laboratory or other party approval of such component part or accessory.

ANY SUCH ACTION MAY POSSIBLY CAUSE A FIRE HAZARD.

When planning a fireplace installation, it’s necessary to determine:

•Where the unit is to be installed.

•The vent system configuration to be used.

•Gas supply piping.

•Electrical wiring.

•Framing and finishing details.

•Whether optional accessories—devices such as a fan, wall switch, or remote control—are desired.

If the fireplace is to be installed on carpeting or tile, or on any combustible material other than wood flooring, the fireplace should be installed on a metal or wood panel that extends the full width and depth of the fireplace.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents What to do if you smell gas Installers GuideSafety and Warning Information Table of Contents Pier-TRC PIER-TRC NG, LP Exploded Parts Diagram / Vue éclatée des piècesST-TRC ST-TRC Corner-TRC CORNER-TRC Corner-TRC Common Parts / Piéces Communes Serial # Part Number High Altitude Installations Installation CodesAppliance Certification CertificationIntroducing the Heat-N-Glo Gas Fireplaces Pre-install PreparationANY Such Action MAY Possibly Cause a Fire Hazard Diagram of the PIER-TRC Diagram of the ST-TRC Diagram of the L & R CORNER-TRC Framing the Fireplace Locating the FireplaceModel 32 156mm 187mm Identifying Vent Components Installing the Vent SystemVent System Approvals Termination kitsMAX .4 M Straight Up Vertical Venting Straight UP Vertical VentingStraight OUT Horizontal Venting Max. RunONE 1 90 Elbow Venting withVenting with ONE 1 90 Elbow Venting with Two 90 Elbows Venting with TWO 2 90 ElbowsVenting with TWO 2 90o Elbows Venting with Three 3 90 Elbows Venting with Three 3 90 Elbows Venting Out the Rear Vent Installing Vent ComponentsVenting Out the Top Vent Attach the First Vent Component to the Starting CollarsAdding Venting Components Install Support BracketsCeiling Firestop Ceiling Side Positioned SO That the Arrow is Pointing UP Vent Termination191mm Minimum Trapezoid CAP TerminationVent Termination Minimum Clearances Minimum Height from Roof to Lowest Discharge Opening Gas Control System Positioning, Leveling, and Securing the FireplaceStanding Pilot Ignition System Nected to Acontrol Valve in Amillivolt SystemGas Pressure Requirements Gas Supply LineNatural Gas Propane For Standing Pilot Ignition Wiring Appliance Requirements Wiring the FireplaceOptional Accessories Wall SwitchOperation using Battery Power For Intermittent Pilot Ignition IPI WiringSealant Material Hearth Extensions FinishingGlass Specifications Installing Trim, Logs & Ember MaterialDouble-check for faulty components After the InstallationBefore Lighting the Fireplace Lighting the FireplaceCleaning Glass Door Fireplace MaintenanceImportant Turn OFF the GAS Before Servicing Your Fireplace Replacing old ember material

L-CORNER-TRC, R-CORNER-TRC, ST-TRC, PIER-TRC specifications

Hearth and Home Technologies offers an impressive range of fireplace products that blend aesthetics with advanced technology. Among their innovative lineup, the PIER-TRC, ST-TRC, R-CORNER-TRC, and L-CORNER-TRC models stand out as versatile and stylish options for modern homes. Each of these fireplace units is designed to enhance the ambiance of a space while providing reliable performance.

The PIER-TRC model is ideal for those seeking a focal point in a living room or gathering space. This pier-style fireplace is characterized by its striking, contemporary design and clean lines. It allows for a three-sided view of the flames, creating a captivating visual experience from various angles. The PIER-TRC incorporates advanced venting technology, ensuring efficient heat distribution without compromising on aesthetics. Homeowners can choose from a selection of decorative media options to personalize the appearance, adding a unique touch to any interior.

Next, the ST-TRC model is a sleek, modern fireplace that excels in providing both form and function. Its space-saving design makes it a perfect choice for smaller rooms while still delivering ample heat output. The ST-TRC features a linear, minimalist look that fits seamlessly with contemporary decor. Advanced electronic ignition systems enable effortless operation, while the option for smart home integration allows users to control the fireplace with ease using mobile devices.

For those looking to create a cozy corner in their living space, both the R-CORNER-TRC and L-CORNER-TRC models offer an excellent solution. Designed specifically for corner placements, these fireplaces feature a unique design that allows for a two-sided viewing experience. The R-CORNER-TRC wraps around the right side, while the L-CORNER-TRC offers a similar aesthetic for the left. Both models utilize cutting-edge technology to ensure efficient heating and combustion, with adjustable flame settings that let users customize their experience.

All of these models come equipped with high-efficiency burners, maximizing heat output while minimizing fuel consumption. Hearth and Home Technologies ensure that each unit meets stringent safety and performance standards. With a commitment to quality and innovation, they provide homeowners with stylish and functional solutions that enhance the warmth and comfort of their living spaces.

In conclusion, the PIER-TRC, ST-TRC, R-CORNER-TRC, and L-CORNER-TRC fireplaces from Hearth and Home Technologies provide a perfect balance of elegance, efficiency, and versatility. Each model showcases advanced technologies and design features that cater to modern needs, making them an excellent choice for any home.
Top Page Image Contents