SYSTEM PROGRAMMING STEPS
PROGRAMMING THE SOURCE COMPONENTS
Step 1 - Press and hold the PROGRAM button for two seconds.
Three LEDs illuminate: ENTER IR, | The POWER OR DISCRETE |
PROGRAM, and SOURCE 2. | “ON” LED blinks. |
Step 2 - If Source Two is turned ON/OFF with IR commands, go directly to Step 3. If Source Two is not turned ON/OFF via IR Commands, press the NEXT button twice and move ahead to Step 8.
Two LEDs illuminate: | The IR COMMANDS LED blinks. |
PROGRAM and SOURCE 2. |
|
Step 3 - Teach the POWER OR DISCRETE “ON” IR command from Source Two’s factory remote control into the IR Sensor Window.
The ENTER IR LED blinks once after the IR command is received and remains illuminated.
The POWER OR DISCRETE “ON” LED blinks.
Three LEDs are illuminated:
ENTER IR, PROGRAM, and SOURCE 2.
61