Sears 390.306062 Electrical Connections, CHARGER/BATTERY Installation, 2x1-1/2x1-1/4, Voltage

[AWARNING[Hazardous fumes. Follow cement manu-

facturer's instructions. Use PVC cement only in a well ventilated place away from fire or flame.

11.Put clamp on adapter;, leave loose. Mount check valve in adapter; thread ag_nbly into tee.

12.Slip pump into check valve. Tighten clamp.

		1-1/2x1-1/2x1-1/4
L__5JZ/Tee" PVC				/
_/	/	Pipe	,r	Check
				ValveC: ]

[_-l,q_--ReducerBushing(2 Supplied)

r---ll

.@_-_-Main PumpDischargePipe

_---,_

i*':_l'€--Check Valve to Prevent

j, I RecirculationintoSump

I u I

L.... J

Figure 2B - Installation Diagram

13.Make sure battery is fully charged; then check operation

by disconnecting power to primary sump pump and fill- ing sump until Backup Sump Pump starts. Run Backup

Pump through one complete cycle.

ELECTRICAL CONNECTIONS

I AWARNINGIE[aZardous				voltage.		Can cause	serious		or
fatal	electrical	shock.	Review		safety	instructions,	Page	2,	be-
fore	operating	charger.
If your outlet		is not	grounded,		install	a copper	wire (at	least

14 gauge)		from	the outlet		box	to	a cold		water	pipe.	Use
ground	clamp		on	pipe. BE	SURE		that	the	cold water		pipe
used	has	metal		continuity	to	electrical			ground.	Battery
charger	is	double		insulated.	DO	NOT		modify cord		or	plug.

3. With charger properly connected and plugged in, the panel on the front of the charger will appear as in one of the following:

A. If battery is dead, charger will supply about 10 amps "power (see Figure 4A).

B. If battery is near full charge, charger will deliver about 5 amps power (see Figure 4B).

Black

Brown

Batten# Clamp

Positive

(Black Iv/

Red Tracer)

Black

1411 1104

Figure 3 - Wiring Connections

A.

CHARGER/BATTERY INSTALLATION

NOTICE: Alarm will sound when charger is first connected

to battery. Press ALARM TEST/RESET button on charger. If

alarm continues to sound, disconnect one charger lead from

-the battery and reconnect it. Press ALARM TEST/RESET again; alarm will stop sounding.

1.Connect charger as shown in Figure 3.

A.Connect Positive (+) lead from charger to positive battery post.

B.Connect Negative (-) lead from charger to negative bat-

tery post. "

C. Third lead from c lMa'ger is factory connected to lead from

pump motor/float switch.

NOTICE: If charger is connected backwards, pump will not operate properly, battery will not charge.

2.Plug in power cord to a 115-125 Volt AC outlet delivering

at least 2 amps. Do not use a switch controlled outlet. Mark circuit in main power panel =Backup sump pump power supply; do not turn off'.

BD

CI

1413 1194

Figure 4 - Battery Backup Control Panel

/L Battery depleted - charging current 10 amps.

B.Battery nearly charged - current about 5 amps.

C.Charge complete - current 0 amps, LED lights up.