leak could occur. Place the Housing and Base right
pointing Into the sink, Allow to stand for 1B minutes.
4.After 15 minutes, rinse the chlorine solution from the Housing and Base by tumtng on the COLD WATER faucet and
sliding the dlverter mechanism, The
system will be adequately rinsed when no chlorine smell is present,
5.Again, hold the filter upside down, unscrew the Filter Housing by turning . clockwise and empty.
6, Remove the plastic wrap and label
from the replacement Filter and place it In the Filter Housing so that the end with
the Cartridge
RESETTINGTHEWATERMETER
CAUTION: After changing the filter you must reset your meter to monitor the life of your new filter. ITISVERY IMPORTANT TO USETHESAME KIND OF FILTERSTHAT WERE SHIPPEDWITH YOUR SYSTEM.THE VALUESTHAT ARE PROGRAMMED INTO THE WATER METERAPPLY ONLY TO THE SYSTEMMANUFACTURER'SFILTER.
TO RESETTHE METER:
WARNING: Resetting the meter is
[E.e_Y_. Please read the following instructions carefully.
Depress and hold the reset button until "RESET? FILTER 1" appears (2 seconds) then release the reset button. The "RESET?" will be flashing. (See Figure 13.)
7, Place the Filter System right
BUttON
Figure 13
Press grid hold the display button for 5 to complete the filter reset, (See
figure 14.) (Notice how the "?" disap-
pears after RESETand it stops flashing). You will hear a confirming beep when the water meter has been reset. The
Page 7