Float/Cage Assembly

WARNING: For your own safety, never connect plug to power source outlet until all assembly steps are complete and you have read and understood the safety and operation instructions. Do not operate vac with any parts damaged or missing.

NOTE: Your Wet/Dry Vac is shipped unassembled. Read the following assem- bly instructions carefully.

1.Grasp tabs on both the right and left side of the power head. Slowly pull tabs away from drum and lift the power head off the drum. Flip the power head and place it in the drum.

2.Locate the float. Place the float over the opening in the center of the lid.

WARNING: To avoid personal injury or damage to vac be sure to keep hands, fingers, or any other foreign I

objects out of the center opening

when assemb ng the float.

3.Line up filter cage tabs with the slots in the center ring of the lid.

4.Push on the filter cage until the tabs snap into the slots for a secure fit. (One tab at a time)

NOTE: If the filter cage needs to be removed, use a slotted screwdriver and insert the blade near one of the tabs

between the filter cage and the center ring of the lid. Pry the tab out of the slot. Tilt the filter cage and lift slightly away from the lid. To replace, follow float/cage assembly instructions.

,/,/__

Powir

Head

Locking Tab'-_

_ Flexible

DrumPull_.t/,_

Lift Up _

Drum/"- _======

_	Filter Cage

Float

Power Head

Lid

Drum

_slo1_(3)-'-