Sears 758.144151 owner manual Check for possible leaks by performing Following

Water Fill (continued)

Notice the water bottles are designed as right and left hand units. Position them in the correct location so the humidifier can

function properly. The water bottles should rest in the front of the cabinet. Each "E-Z-

Fill Side-Cap" must be facing the rear of the unit.

Each water bottle is designed with an =E- Z-Fill Side-Cap" that is easily removable, Remove the =E-Z-Fill Side-Cap" on the

side of the water bottle by twisting coun- terclockwise.

Place the opening of the water bottle under a water faucet (the bottle should fit under a four-inch clearance faucet). Fill with rec- ommended mixture of cold water and Sears Bacteriostat #42-14900 (if neces-

sary) only. Solid debris could make the valve leak.

Install the "E-Z-Fill Side-Cap" by twisting clockwise, Hand tighten only.

Check for possible leaks by performing

the following:

1.Grasp bottle handle and hold the bottle upright over a sink.

2.Press up on valve cap plunger for about one second to let out a little water.

3.Release the plunger.

4.Listen for air bubbles. Look for leaks around the "E-Z-Fill Side-Cap".

5.If you hear air bubbles or see leaks, retighten the "E-Z-Fill Side-Cap" and repeat steps 1-4.

Wipe off excess water from the bottle. Position the water bottle back into the unit

by grasping the water bottle handle and lower it into the cabinet until the bottle sits

on pads at bottom of cabinet. The =E-Z-FillSide-Cap" must be facing the rear of the cabinet, When positioned properly, the plunger will open and water will flow into the cabinet. The water level will automati- cally remain at approximately 1/2" until the

bottles are empty.

The unit is now ready for operation.

___-'_ Rear of

,_ _"'_ Humidifier

"E-Z-Fill Side-Cap"

Should Always Face Rear

Turn Counterclockwise

ove Cap

Valve

Cap Plunger

Pivoting Lid

Removed

for Clarity

6