Honeywell 96D user manual System Programming

Page 23

System Programming

Programming Interface

System Programming

The system’s Normal programming mode offers several menu options that are accessible from the main menu screen:

Tx Info:

Allows transmitter parameters to be programmed

Groups:

Allows groups of transmitters to be set up

Events:

Allows events and event behavior to be programmed

Acqui:

Allows the datalogging feature to be activated or deactivated

Copy:

Allows data or parameters to be copied from the (controller)

 

configuration to parameters

Config:

Allows system parameters and password to be set

Network: Allows actions on the network to be performed,

 

communication statistics to be consulted, and remote

 

calibrations to be performed

Tests:

Allows each device to be tested sequentially (inputs, outputs,

 

communications, events, etc.) and operation of various

 

parameters to be validated

BACNet:

Allows a device’s BACNet parameters to be set

Wireless: Allows a network of wireless gas detection devices to be configured, monitored, and modified.

Note: Access to the programming functions is password protected. The default password is 2967.

The screen display shown below appears initially. This display can be configured to scroll among the information screens for each device connected to the controller.

If one or more of the connected devices is in an alarm mode, the controller will only scroll between the main information screen and the screens for device(s) in alarm mode. In this case, you must scroll manually to view screens for other devices.

20

96d User Manual

M-511401

 

Honeywell

8/10

Image 23
Contents 96d Controller Unit Page Controller Unit 96dPage Copyright by Honeywell International Inc August Page Symbol Definitions Page Introduction Warranty Page Page Receiving and Unpacking Intended UseBasic Guidelines Installation InstructionsSurface Mount Installation $ $ Wiring DetailsIntroduction Communication Connections Power ConnectionsRelay Output Jumper Use Instructions Datalogger SDcard Initial StartupKeypad Functions Programming InterfaceSystem Programming IconDescription Password COM Tx Info MenuIdent Menu Product and Sensor Types System Programming COM Menu Scale Menus 1 Detection Menu Display Menu Alarm A, B and C Menus Servicing and Operating Menus Erase Current Tx Status CodeChange Tx Address Groups Menu Creating Groups Deleting Groups Event Menu System Programming Action Menu Delays Menu Latch Mode Conditions System Programming Operator Symbol Meaning OFF Database StatusAcquisition Menu Starting and Stopping Tx Logging Starting and Stopping Event Logging Copy Menu ConfigurationParameters System Log Menu Menu Config MenuConfig Manual scroll mode Set Date and Time Menu français Config Set User Password 2967 Slave Port Cnfg Config Relay Configuration AP Brdcst auto Honeywell Config Day definition Week definition Network Menu Network Statistics Calibration Remote Calibration Calib 001 301D2 Status Normal Set Zero Set Span 60 ppm Menu Tests MenuTests Test sequence Start Sim Sequence Maximum load Test Sequence Test sequence Display test Any key to continue Esc to quit Debug Mode Normal ModeSingle Tx Mode Simulation Mode BACnet Menu Wireless Network Menu Specifications Page Warranty Conditions WarrantyConsumer Claims Warranty Page Technical Services