FINISHING THE INSTALLATION
ADJUSTING THE FEET
The SW10 and SW12 are equipped with four adjustable spiked feet,
•On hard floors (e.g., wood, tile, etc.), check the SW10 and SW12’s stability and, if needed, adjust the rubber feet one at a time until the cabinet is level.
•On carpeted floors, tilt the SW10 and SW12 up and remove each rubber cover. Check the SW10 and SW12’s stability and, if needed, adjust the spikes one at a time until the cabinet is level.
CONNECTING THE SW10 AND SW12
Connect the SW10 and SW12 according to your application (see APPLICATIONS on page 10). Use
1.At each SW10 and SW12
NOTE: OBSERVE CORRECT POLARITY: POSITIVE (+) GOES TO THE RED POST AND NEGATIVE
(–)GOES TO THE BLACK POST. IF YOU ARE UNSURE OF WIRE POLARITY, SEE THE SECTION, CHECKING PHASE ON THE SATELLITE LOUDSPEAKERS, ON PAGE 14.
2.Connect the other end of the loudspeaker wires to the home theater receiver (or amplifier) and satellite loudspeakers in the same way.
3.Using the
4.Turn on the home theater receiver and calibrate all loudspeakers in the system according to the receiver (processor) manufacturer’s instructions.
NILES AUDIO CORPORATION – |
| 13 |
|