Niles Audio SW10, SW12 manual Installing and Removing the Grille, Cleaning

Of course, there are some wires that appear completely identical. If wired incorrectly, one satellite loudspeaker will be playing “out-of-phase” with the other loudspeaker. A pair of out-of-phase loudspeakers works against each other, and the sound of the two playing together will be lacking in bass and sound “phasey.” If you suspect the sound is not right, and you cannot see any markings on the wire, try this simple test:

1.Stand halfway between the satellite loudspeakers.

2.Play some music with the amplifier or receiver set to Mono.

3.Listen to the richness of the bass and the loudness of the sound.

4.Turn off the amplifier and reverse the connections on the SW10 and SW12 SPEAKER OUT

binding post.

5.Repeat the listening test with the same volume control setting. When the sound has a richer bass and is slightly louder, the satellite loudspeakers are working together or “in-phase.”

INSTALLING AND REMOVING THE GRILLE

•To install the grille, start with the top two grille posts and gently press the grille frame in at each of the five recessed holes. When properly installed, the grille will be approximately 2 to 3 mm away from the cabinet along the sides.

•To remove the grille, start with the bottom grille posts and gently pull the grille frame away from the SW10 and SW12’s edge at each of the five recessed holes. Store the grille in a safe place for future use.

CLEANING

Use a dampened soft cloth or paper towel to clean the cabinet and grille.