Dimplex MCN20 Controls, Battery information, Manual or Remote Operation, Maintenance

Operation

The unique flame effect may be enjoyed whether or not the heating elements are in operation.

Controls

The heater controls are located on the left hand side of the canopy heat outlet - see Fig. 1.

A switch is in the ON position when the red indicator mark on the switch is visible.

Note: When either the remote control or the manual controls are used, the neon’s will come on for 3 seconds indicating the relevant setting (see Fig. 3).

neon’s for indicating the operation level

On

Button

Off

Button

Remote Control

Warning: it takes time for the receiver to respond to the transmitter. Do not press the buttons more than once within two seconds for correct operation.

Increase

Brightness

Fig. 3

Battery information

Batteries

Fig. 4

	Decrease
	Brightness
	Standby
	Switch
OFF	ON

Manual Controls

Note : The Standby Switch must first be turned on to operate either the manual or the remote controls.

1.Slide open the battery cover on the back of the remote control

2.Install two AAA batteries into the remote control (see Fig. 4)

3.Replace the battery cover.

Discard leaky batteries

Dispose of batteries in the proper manner according to Provincial and local regulations. Any battery may leak electrolyte if mixed with a different battery type, if inserted

		Fig. 2
Manual or Remote Operation
Setting	Operation	Indication
Flame effect	Press the ‘ON’ button once	Top Neon
Flame effect & 1kW heat	Press the ‘ON’ button again	Top & Middle
		Neon
Flame effect & 2kW heat	Press the ‘ON’ button again	All 3 Neon’s
To turn off any of the	Press the ‘OFF’ button once
settings

To increase or decrease the brightness of the fuel effect use the buttons as shown in Fig. 2

Setting the Thermostat

Plug in and set all switches to ON. Turn the thermostat knob to MAX to warm the room rapidly. When the room temperature has reached the desired level, turn the thermostat knob back slowly until the thermostat just clicks off. The heater will then maintain the room temperature at the chosen level.

NOTE – Should your heater fail to come on when the thermostat is at a low setting, this may be due to the room temperature being higher than the thermostat setting.

Maintenance

WARNING – BEFORE UNDERTAKING ANY MAINTENANCE OR CLEANING, REMOVE PLUG OR DISCONNECT FROM THE ELECTRICITY SUPPLY.

incorrectly, if all the batteries are not replaced at the same time, if disposed of in a fire or if an attempt is made to charge a battery not intended to be recharged.

Lamp Replacement

There are two lamps located beneath the fuel effect. To gain access to the lamp, the fuel effect which is secured by three screws, must be removed (see Fig.1).

Remove the coal/pebbles and carefully lift the fuel effect/fuel effect trim clear and set aside.

Remove the glass shelf and carefully set aside.

Replace the defective lamp with a 240V 60 Watt E14 SES clear candle lamp.

Replace the glass shelf then the fuel effect assy and secure with screws.

Safety cut-out

For your safety, this appliance has been fitted with thermal cut-out. In the event that the product overheats, the cut-out switches the heat off automatically.

To bring the heat back into operation, remove the cause of the overheating, then unplug or turn off the electrical supply to the heater for up to 10 minutes.

When the heater has cooled sufficiently, re-connect and switch on the heater.

Caution: Inorder to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.