Bradford-White Corp warranty Dimensions Millivolt Models

Dimensions

Millivolt Models

	B	B
	H	H
	T & P	T & P
	HOT	HOT
		G
G
	C	A
A		D
D	CLEANOUT
	COLD	E
	E	F
F
Water Connections		Water Connections
Top and Front	Top Front, Rear	Front and Rear
DM75T125	DM100L199, 250, 270	DM75T160
DM80T180, 199, 250	DM100S199, 250	DM38T155
DM100T199, 250

Sample Specification

The water heater shall be a Bradford White model with a storage capacity of not less than ____________ gallons (____________ liters), a minimum

gas input of ____________ BTUH (KWH), and a minimum recovery of _______ GPH (LPH) at 100°F (56°C). temperature rise. It shall be design

certified by CSA International (formerly AGA and CGA) for 180°F (82°C). application, either with or without a separate storage tank. The tank shall be lined with Vitraglas® vitreous enamel and shall have a bolted hand hole cleanout. The tank shall have ____________ extruded magnesium anode

rods installed in separate head couplings and extended to within three inches of the bottom. The heater shall be insulated with non-CFC foam insulation. This water heater shall be equipped with an ASME rated T&P relief valve, a continuous pilot ignition system and flue damper. The entire installation shall be made in compliance with state and local codes and ordinances.

Dimensions and specifications subject to change without notice in accordance with our policy of continuous product improvement.