Aube Technologies TH104 installation instructions Nstallati on, Connect the thermostat

				TH1 04
		Installation Instructions and Owner￿ s Guide
	To set the day	FAN: displayed when	Current time	SETPOINT:
	To set the
	time	conventional temperature	and day	displayed when
	To set the	control is selected		viewing or
				setting the
	minutes			temperature
		Heating		TIME: displayed
	To access	indicators
	programming mode			when time needs
				to be adjusted
	and view programs
		Room		LP: displayed
		temperature
	To exit a function			during a power
				failure
		Current program
	MODE: to select the	number when the
	desired operating mode	Automatic mode		Current program
		is active		number when
	Temperature			Econo schedule
				is active
	adjustment
RESET:	buttons	Automatic		Econo
			Manual
To reset the		mode		mode
			mode
thermostat

I NSTALLATI ON

This thermostat has been designed to control a RESISTIVE load not exceeding 3500 W @ 240 VAC or 1750 W @ 120 VAC, such as electric baseboards, convectors, radiant ceilings, floor heating sys- tems, etc.

It is not compatible with a low voltage controller used by a cen- tral heating system or systems using a contactor or a relay whose current is under 2 A.

TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN POWER PANEL TO AVOID ELECTRICAL SHOCK. Installation should be carried out by an electrician.

This thermostat is designed to be used with a self-pro- tected heating system equipped with linear limit control and circuit breaker.

For a new installation, choose a location about 5 ft. (1.5 m) above the floor, facing the heating system and on an inside wall.

Avoid locations where there are air drafts (top of staircase, air outlet), dead air spots (behind a door), direct sunlight or con- cealed chimneys or stove pipes.

All cables and connections must conform to the local electrical code.

Special CO/ALR solderless connectors must be used when

￿connecting with aluminum conductors.

The wires are not polarized, therefore the connections can be made on either terminal.

PROVIDED PARTS

!One (1) TH104 thermostat

"Two (2) 6-32 mounting screws

#Two (2) solderless connectors

1 ) Connect the thermostat

Connect the rear wires to the power and load using solderless con- nectors for copper wires.

2 WIRES
4 WIRES
1/4	400-104-000-A