The chime can be mounted vertically or horizontally (depending on model) using 2 holes in back of case, or using one keyhole and one mounting hole. It is highly recommended to use at least two mounting screws with anchors.
It is recommended to secure chime to wall using screws and anchors through both holes.
Snap cover onto chime as shown.
Keyholes |
Pry with a small screwdriver to remove case before installing.
To remove cover after base is mounted, firmly grasp cover and pull.
Note: Model
Warning: Model
Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any jumpers on your chime and push button.
The push button and chime communicate by using a code that can be changed by removing and/or adding jumpers on both the push button and chime. The code is factory set; however, there are 128 selectable codes that allow you to expand your system and prevent outside interference. Other wireless prod- ucts may cause interference and the system may not function properly. Fol- low the instructions below for setting a new code.
1.Open the cases and locate the jumpers on both the push button and chime (See illustration on page 3).
2.The push button and chime both have eight different jumper locations. The jumper positions 1 through 7 are used for setting the code.
3.To change the code, add and/or remove jumpers as needed. It is recom- mended to only change one jumper at a time and then check to see if system is functioning properly. Note: Jumpers in positions 1 through 7 must be exactly the same for both the push button and chime for this system to function.