Gianni Industries EASIPROX-ANSI, Easiprox III. The indicator signal chart, IV. Wiring diagram

III.The indicator signal chart:

	Signal	Condition
User Signals	Yellow	Power on, Stand-by
	Green	Lock relay active
	Red	Invalid Card
	Yellow、Green Flashing	The memory is empty
	Green Flashing	Into the ADD CARDS MODE
Programming	Red Flashing	Into the DELETE CARDS MODE
	Yellow、Red Flashing	Into the CLEAR MEMORY MODE
Signals
	Yellow Flashing	Into the TIME ADJUST MODE
	Green Blinking	Clearing Memory

IV. Wiring diagram:

Power Supply

Push Button (N.O./Com.)

Electric Strike

(Fail-Secure Typical)

Electric magnet (Fail-safe Typical)

Note:

1.The suggested wire gauge is #22~26 AWG.

2.The varistor or diode must be connected across the lock terminal (electromagnet...) operated by the device. The vartistor controls the overload produced by the strike coil (EMP).

3.Using a Linear supply power recommended, to prevent power reduction at the card reader.

Copyright © Gianni Industries, Inc. All Rights Reserved.
P-MU-EASIPROX Ver. B Published on 2008.02.12	Page: 2/ 4