Card Simulator / Programmer (optional)
The Card Simulator allows adding and removing any card/card number from the reader memory when the card is lost or not available. One unit can be utilized at different sites but for security reasons it will operate only in conjunction with the Master Card.
The Card Simulator / Programmer cannot be used to gain access. It will only operate together with the reader's MASTER card
¾Setting Card Number Hold the On/Off button down.
Use the RIGHT ARROW key to move the cursor to the digit to be changed. Use the UP ARROW key to change the number at the cursor.
Repeat the above until all the digits of the number are correct.
This number is stored in memory and the On/Off button may now be released.
¾Battery
The unit is powered by a PP3 9V battery. Undo the 2 screws at the back of the unit to gain access to the battery.
¾Deleting Cards
The MASTER card must be used to put the reader into the Delete mode. RED lamp flashes
Place the Card Simulator close to the reader
Hold down the On/Off button and check the displayed number Press the Send button
The GREEN lamp will flash to verify that the selected number is deleted and then the RED lamp will continue flashing.
Once the card or a group of cards have been deleted, read the Master Card to return to the RUN state.
¾Adding Cards
The MASTER card must be used to put the reader into the Add mode. GREEN lamp flashes
Place the Card Simulator close to the reader
Hold down the On/Off button and check the displayed number Press the Send button
The GREEN lamp will go steady and the relay will operate to verify that the selected number is added. The GREEN lamp will then continue flashing.
Once the card or a group of cards have been added, read the Master Card to return to the
Copyright © Gianni Industries, Inc. All Rights Reserved. |
|
Page: 4/ 4 |