PROGRAMMING INSTRUCTIONS 
Write the settings of your transmitter DIP switches into the Transmitter Code table:
1 | 2 | 3 | 4 |
Factory Default
# # 1
#
Your Transmitter Code
STEP 3: Now program your keypad:
1.Press the ON/Reset button.
2.Enter the Factory Default PIN, 1, 2, 3, 4
3.Press key #
4.Press key #
The Transmitter Code is now programmed into your Keypad.
5.Press key 1
6.Enter the Transmitter Code you filled in above
7.Press key #
Dual or Triple Button Transmitter
If your gate or door operator has a two or three button transmitter:
STEP 1: Locate your transmitter and open the coding hatch. You will see a coding switch block with numbers from 1 to 8 The possible setting for each switch is either “+”, “0” or
+ = 1 | 0 = 2 | - = 3 |
STEP 2: Copy the transmitter code as it is currently set into the table below.
For example, Figure 4 shows DIP switch settings of:
1 2 3 4 5 6 7 8
+
0
-
Example Table:
Figure 4
+, 0, +, -, +, 0, +, -
The numeric equivalent is: 1, 2, 1, 3, 1, 2, 1, 3
1 2 3 4 # # 1 1 2 1 3 1 2 1 3 
#
Primary PIN | DIP Switch Settings from | Transmitter |
| Transmitter | Button Code |
|
|
Write the settings of your transmitter DIP switches into the Transmitter Code table:
Note the “Transmitter Button Code” box in the table below. You must also program the code for the specific transmitter button that you will use to open the gate or door. On a two button transmitter, the left button code is 1, and right button code is 2. On a three button transmitter the left button code is 1, the middle button code is 2, and the right button code is 3. If you are programming the keypad so that the left transmitter button opens the gate or door, you will enter a 1 in the “Transmitter Button Code” box below.
1 | 2 | 3 | 4 |
Factory Default
# # 1
#
Your Transmitter Code | Transmitter Button |
| Code |
STEP 3: Now program your keypad:
1.Press the ON/Reset button.
2.Enter the Factory Default PIN, 1, 2, 3, 4
3.Press key #
4.Press key #
The Transmitter Code is now programmed into your Keypad.
5.Press key 1
6.Enter the Transmitter Code you filled in above
7.Enter the Transmitter Button Code you filled in above
8.Press key #
3