READ AND SAVE THESE INSTRUCTIONS
HOW TO USE THE TOUCHPAD CONTROL KEYS
The Touchpad on the Evolution LGR has one display and four keys. The normal display messages are:
DEHUMIDIFIER OFF | CMPRSR DELAY |
DEHUMIDIFIER ON | PUMP PURGING |
TOTAL HRS | DEFROST ON |
JOB HRS | GET SERVICE ERO1 |
| When you first plug in the unit, the touchpad display will cycle con- | |||
| tinuously through three messages: DEHUMIDIFER OFF, TOTAL | |||
IIlustration of Touchpad | HOURS, and JOB HOURS. | |||
|
|
|
| |
| ||||
| turning the machine on, usually the display reads CMPRSR | |||
| DELAY and performs a numeral count down from a maximum of | |||
| 60 seconds to 0. The compressor delay gives the machine time to | |||
| warm up when needed. If you don’t see a compressor delay | |||
| countdown, the machine is ready to go. Once the unit completes | |||
| the CMPRSR DELAY, the display reads DEHUMIDIFIER ON, and | |||
| continues to cycle between TOTAL HOURS, JOB HOURS and | |||
| DEHUMIDIFIER ON. | |||
| Press the | |||
| read DEHUMIDIFIER OFF. | |||
| DISPLAY. Press the DISPLAY key to stop the display at DEHU- | |||
| MIDIFER ON or OFF, TOTAL HOURS, or JOB HOURS as it cycles. | |||
| Press DISPLAY again to | |||
| How to change the language display | |||
|
|
|
|
|
|
| CAUTION |
|
|
While in the
Use the DISPLAY key to change the display language.
Follow these steps:
1.Start with the unit unplugged.
2.While holding down the DISPLAY key, plug the unit in. The display reads ENGLISH.
3.To change to FRANCAIS, DEUTSCH, or ESPANOL, press the DISPLAY key or the CLEAR key.
4.When the desired language is shown in the display, unplug the unit, and the language is set.
CLEAR. Press the CLEAR key to reset the JOB HOURS:
1. As the display cycles between DEHUMIDIFIER ON, JOB HOURS, OR TOTAL HOURS, press the DISPLAY key when JOB HOURS appears on the screen. That will make the display read JOB HOURS steadily.
2. Then press the CLEAR key to
3. Press DISPLAY again to
4