LG Electronics LP7000R, LP6000ER owner manual Secure the Curtain Frames

5SECURE THE CURTAIN FRAMES

Expand the curtain frames and secure them using 5 screws (ITEM E) as shown in FIG. 7.

When curtain frame opens or closes, you may feel a slight resistance. This is normal.

6 FOAM SEAL AND WINDOW LOCK

•Cut the foam seal (ITEM F) to the window width. Stuff the foam seal between the glass and the window to prevent air and insects from getting into the room, as shown in FIG.7.

•Install the L bracket to prevent window from being raised which may result in unit falling.

L BRACKET

FOAM SEAL

(ITEM F)

ITEM E

FIG. 7

7IF AIR CONDITIONER IS BLOCKED BY STORM WINDOW FRAME

•If storm window presents interference, fasten a 2"(51mm) wide wood strip to the inner window sill across the full width of the sill. The wood strip should be thick enough to raise the height of the window sill so that unit can be installed without interference from the the storm window frame. See FIG. 8.

Top of wood strip should be approximately 3/4"(19mm) higher than the storm window frame to help condensation to drain properly to the outside.

•Install a second wood strip (approximately 6"(152mm) long by 11/2"(38mm) wide and same thickness as first strip) in the center of the outer sill flush against the back of the inner sill. (FIG. 8)

	1 1/2" min.	3/4"(19mm)
WOOD STRIP MOUNTED	(38mm)	CLEARANCE
ON TOP OF INNER SILL
		STORM
INNER		WINDOW
		FRAME
SILL
WOOD STRIP
FOR SUPPORT
	BRACKET	OUTER
		SILL
INDOOR		OUTDOOR
When storm window
frame is located on outer sill
		FIG. 8

CAUTION

Failure to securely install support bracket may result in unit falling from window if window sash is raised after unit is installed. This could result in personal injury.

NOTE: If window sash has a metal surface. use sheet metal screws instead of the provided wood screws. Obtain sheet metal screws at local hardware store.

8INSTALLATION FOR OTHER TYPE WINDOWS.

•Dimensions and geometry of windows are different according to manufacturers. Check your window and refer to FIG.9 to install the support bracket firmly.

14