LG Electronics LWC183PLMD1, HB1803R, LWP1830WAL, LWP1820PDL Refrigerating Cycle, Motor, Evaporator

Disassembly

11. Motor

1. Remove the cabinet. (Refer to section 2)

2. Remove the turbo fan. (Refer to section 4)

3. Remove the fan. (Refer to section 5)

4. Remove the 4 screws that fasten the motor from the air guide. (See Figure 27)

5. Remove the motor.

6. Re-install the components by referring to the removal procedure, above.(See Figure 27)

Figure 27

RefrigeratingCycle

12. Condenser

CAUTION: Discharge the refrigerant system using a FreonTM Recovery

System. If there is no valve to attach the recovery system, install one (such as a WATCO A-1) before venting the FreonTM. Leave the valve in place after servicing the system.

1.Remove the cabinet. (Refer to section 2)

2.Remove the 4 screws that fasten the brace.(Refer to section 4)

3.Remove the 5 screws that fasten the condenser and shroud.

4.After discharging the refrigerant completely, unbraze the interconnecting tube at the con- denser connections.

5.Remove the condenser.

6.Re-install the components by referring to notes. (See Figure 28)

13.Evaporator

1.Remove the control box.(Refer to section 3)

2.Remove the air guide upper. (Refer to section 4)

3.Remove the 2 screws that fasten the evapora- tor.

4.Move the evaporator sideways carefully. (Refer to section 4)

5.After discharging the refrigerant completely, unbraze the interconnecting tube at the evapo- rator connections.

6.Remove the evaporator.

7.Re-install the components by referring to notes. (See Figure 29)

Figure 28

Figure 29

20Room Air Conditioner