C A U IT IO N
D O N O T O PEN
CAUTION:TOPREVENTTHE RISKOFELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO
REFERSERVICINGTOQUALIFIEDSERVICEPERSON- NEL.
WARNING: TO PREVENT FIR OR SHOCK HAZARD, DO NOTEXPOSETHISAPPLIANCETORAINOR MOISTURE.
This symbol indicates that dangerous volt- age constituting a risk of electric shock is
present within this unit.
This symbol indicates that there are impor- tant operating and maintenance instructions
in the literature accompanying this unit.
WARNING:UNAUTHORIZEDRECORDING OFCOPYRIGHTED MATERIAL MAY VIOLATE APPLICABLE COPYRIGHT LAWS, MANUFACTURER ASSUMES NO RESPONSIBILITY FORUNAU- THORIZED DUPLICATION, USE OR OTHER ACTS WHICH INFRINGE UPON THE RIGHT S OF COPYRIGHT OWNERS.
Explanation of Symbols
This symbol is intended to alert the user of the presence of uninsulated
''dangerous voltage'' within the product encasement that may be of sufficient magnirude to constitute a risk of electric shock to persons.
This symbol is intend- ed to alert the user of the presence of important operating and maintenance (servicing) instruc- tions in the literature accompanying the appliance.
WARNING
To prevent fire or shock haz- ard, do not expose this appli- ance to rain or moisture.
If this happens, make sure the power to the electrical outlet is turned off before.
SAFETYCERTIFICATION
This unit is made and tested to meet exacting safety standards. It meets UL and FCC requirements and complies with safety performance standards of the U.S Department of Health and Human Services.
FORMANCEOFPROCEDURESOTHERTHANTHOSESPECIFIED
HEREINMAYRESULTINHAZARDOUSRADIATIONEXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANY-
ONEEXCEPTPROPERLYQUALIFIEDSERVICEPERSONNEL.
FCCINFORMATION
For CD player section:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FOC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, If not installed and used in
'
accordance with the Installed and used in accordance with the Instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 
Relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into outlet on a circuit different from that to which the receiver is connected. 
Consult the dealer or an experienced radio/TV technician for help.