Shark NV360 Maintenance cont’d, Cleaning the PET Power Brush, Cleaning the POST-MOTOR Hepa Filter

Maintenance - cont’d

Fig. 22

Fig. 23 Fig. 24

CLEANING THE PET POWER BRUSH

1Slide the locking latch (a) forward and gently tilt brush housing upward to open. (Fig. 25)

IMPORTANT: DO NOT force; it will not open all the way.

2Carefully remove any blockage or debris.

3Turn the pet power brush over to inspect the rotating brush and cut away any build-up of hair or string wrapped around the rotating bristle brush with scissors. (Fig. 26)

4Push the housing back down and slide the locking latch backward to lock.

a

CLEANING THE POST-MOTOR HEPA FILTER

Fig. 25

Fig. 26

1Remove the filter cover from the front of the vacuum by pulling up on the tab and pulling the cover away from the vacuum. (Fig. 22)

2Take out the HEPA filter by pulling it straight out.

3Turn the filter over so that the dirty side is on the bottom and vigorously tap it clean against a garbage can to remove any dust. (Fig. 23)

4Wash the filter under the tap using lukewarm water with the dirty side face down until the water runs clear. (Fig. 24)

DO NOT put the filter in the washing machine or dishwasher.

NOTE: The material in the filter will discolor over time. This is NORMAL and will not affect the performance of the filter.

5Allow the filter to air dry for 24 hours. Do not use a hair dryer or other heating methods to dry.

6Once the HEPA filter is dry, replace it back into the vacuum.

7Replace the cover by inserting the two tabs into the holes at the top and then swinging the cover down until it clicks into place.

14 TOLL FREE: 1-800-798-7398

Rotating

Brush

Fig. 27

CLEANING THE MOTORIZED FLOOR BRUSH

When your motorized floor brush needs cleaning or locks onto an object, it automatically shuts down to prevent damage to your lifetime belt. The indicator light will illuminate red warning you to turn off the vacuum and clear blockage immediately. The light will reset itself once blockage has been cleared and power has been cycled on/off or vacuum has been locked in the upright position.

1Detach the motorized floor brush from the portable Lift-Away®canister.

2Inspect the opening underneath and the rotating brush. If a build-up of debris is present, remove it. Carefully cut anything wound around the rotating brush with scissors. Avoid damaging or cutting the bristles. (Fig. 27)

NV360_26_IB_E_121119_1.indd 14

12-11-19 8:59 AM