Shark NH130 Checking for Blockages, Not Rinse, Cleaning the Post Motor Foam Filter, Dust CUP

a

Exhaust Foam Filter

b

DO

NOT

RINSE

Felt Filter

Checking for Blockages

c

Locking

Latch

		Turbine
		Wheel
Rotating	d	e
Bristle
Brush

CLEANING THE POST MOTOR FOAM FILTER

1Lay the Vacuum down with the Handle facing up.

2Twist the Exhaust Filter Compartment so that the Black Triangle on the Handle aligns with the ‘Unlock’ Symbol on the Exhaust Filter Compartment and remove. (fig. a)

3Pull out Foam Filter.

4Rinse only the Foam Filter thoroughly in lukewarm water until the water runs clear.

5Squeeze out excess water and let air- dry for 24 hours before replacing; do not use hair dryer or other heating methods to dry.

6Make sure the filter is completely dry and insert it back into Exhaust Filter Compartment.

12 TOLL FREE: 1-800-798-7398

7Grip Exhaust Filter Compartment and align ‘Unlock’ Symbol with Black Triangle on Handle of the Vacuum.

8Push Exhaust Filter Compartment into Vacuum and twist so that the Black Triangle on the Handle aligns with the ‘Locked’ Symbol on the Exhaust Filter Compartment to lock it into place. (fig. b)

DO NOT operate the vacuum without ALL the filters in place.

DO NOT operate the vacuum with WET filters.

Blockages may cause your vacuum to overheat and shut down. To prevent this from happening, check potential blockage areas after heavy use or if you detect a loss of suction or poor cleaning performance.

1DUST CUP

Dust Cup may be full. Empty Dust Cup. For instructions on how to empty the Dust Cup, see p. 10.

2FILTERS (FOAM AND FELT) Ensure that both the Pre and Post Motor Filters are clean. For cleaning instructions see p.11 & 12.

3ACCESSORIES

•Check intake openings:

•2-in-1 Crevice/Dusting Tool

•Pet Hair Power Brush

•Long Reach Crevice Tool

CLEANING THE PET HAIR POWER BRUSH

•Turn the Pet Hair Power Brush over, slide the locking latch forward

and tilt the cover upward to remove. (fig. c)

•Inspect the rotating bristle brush, turbine wheel and air passage. (fig. d)

•Remove any blockage or debris and carefully, without damaging the bristles or belt, cut any build-up of hair or string wrapped around the rotating bristle brush with scissors.

•To reassemble, first insert the tabs on the front edge of the cover into the matching holes in the top half of the Pet Hair Power Brush and tilt the cover back down pressing until it clicks into place. (fig. e)

www.sharkclean.com 13