Operating Instructions Precautionary Measures

Fig. A

Wash once a month or when suction appears reduced.

Warning: Allow 24 hours for air drying before replacing in unit.

OPERATING INSTRUCTIONS

PRECAUTIONARY MEASURES

Cleaning & Changing the HEPA- Type Filter

PLEASE NOTE: The white pleated filter material in the HEPA-Type dust cup filter will discolor over time -This is NORMAL and will NOT affect the performance of the filter. If the HEPA- Type dust cup

CAUTION: The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged. Warning: Always empty the dust cup container and clean the HEPA-Type filter before each use and during prolonged usage.

Never over fill the dust cup (container) -

IMPORTANT: If the suction opening in the unit or the hose is BLOCKED, switch off the vacuum cleaner and remove the blocking substance before you start the unit again.

1. Do not operate the vacuum cleaner	4. When pulling out the power plug
too close to heaters or radiators.	from the wall outlet, pull the plug not
	the power cord.

filter is properly "TapCleaned” after each use and suction does not return to 100%, then we suggest that the HEPA-Type filter be “TapCleaned” vigorously until no

more dust can be removed, then rinsed under the faucet and allowed to air dry for 24 hours before refitting into the vacuum. (Fig. A) Wash once a month or when suction appears reduced.

Re-Installing Dust Cup (Container)

1.Ensure that small air intake vent on the dust cup is aligned with the opening on the main unit. (Fig. 12)

2.Slide the dust cup container into place and lower the dust cup retainer handle.

3.Push retainer handle until you hear it lock into place. (Fig. 13)

Air Intake

Vent

Fig. 12

Fig. 13

remove dirt and clean the HEPA-Type filter when dirt in dust cup is at or below the "MAX" level during prolonged usage or risk motor damage.

If you wash the HEPA-Type filter, make sure that it is completely air dry before inserting back in the vacuum.

Please Note: The HEPA-Type filter is washable. It should, however, be replaced every three (3) to six (6) months, depending on usage to ensure peak performance of your vacuum.

Motor Thermostat

Important: This unit is equipped with a motor protective thermostat. If for some reason the vacuum cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur:

•Push the On/Off button once.

•Disconnect the plug from the power source.

•Check the source of overheating problem. (i.e. clogged hose or filter)

•If clogged hose or filter is found, unclog the hose and replace the filters.

•Wait at least 45 minutes before attempting to reuse the vacuum.

•After unit has cooled down for

45 minutes, plug in the cleaner and push the On/Off button. The vacuum should start again.

•If the vacuum still does not start, contact customer service at

1 (800) 798-7398.

2.Before inserting the power plug into the wall outlet, make sure that your hands are dry.

3.Before you start vacuuming, make sure to remove large or sharp objects that might cause damage to the unit.

5.Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes.

6.Do not vacuum any liquids.

7.Do not use without dust cup (container) or HEPA-Type filter in place.

Note: This vacuum cleaner is equipped with a plug and power cord that retract automatically. If the cord or plug get damaged, it must be replaced by a qualified technician.

Warning: Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding.