Operating Instructions, Emptying The Dust Cup

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS cont.

NOTE: Always remove the power plug from the wall outlet before assembling or removing accessories.

INSERTING THE 2-PIECE METAL HANDLE INTO THE MAIN BODY

•Push in the pin at the end of the lower piece of the metal handle (see illustration).

•Insert the metal handle into the hole next to the handle. Make sure that the slot in the handle fits correctly into the opening. (See illustration.)

•When inserted correctly, the pin should rest in its hole.

Hole

ATTACHING THE HOSE TO THE MAIN BODY

•Press in the pin at the end of the hose (see illustration below).

•Insert the hose into its place (see arrow in illustration).

•When inserted correctly, the pin will show in the pin hole.

Pin Hole

WINDING & UNWINDING THE POWER CORD

•To wind the cord after usage, follow the illustration below.

•To unwind the power cord, follow the illustration below but in the opposite direction.

•When using the vacuum, attach the cord to the cord holder so that the cord is out of the way when you are vacuuming. (See below.)

Top of Retractable Handle

Cord Holder

USING THE UNIT AS AN UPRIGHT

Crevice Tool

For radiators, crevices, corners, baseboards and

between cushions.

Dusting Brush

The dusting brush is used for the furniture, venetian blinds, books, lamp shades

and shelves.

Emptying The Dust Cup

Warning: Always unplug the unit from electrical outlet before opening the Dust Cup (container).

•	Hold the dust cup in your hand.
• Turn it a complete 90° in the direction
	shown in drawing #1. (Turning less than
	90° will cause the dust cup to be
	attached on its bottom.)
•	Let the dust cup come down slightly as
	shown in drawing #2.
•	Slide the dust cup out towards you (see
	arrow in drawing #3).

•To insert the upper piece of the metal handle, press on the pin that is on the upper handle and insert into the lower handle making sure that the pin comes out of the pinhole on the lower handle.

ATTACHING THE FLOOR BRUSH TO THE MAIN BODY

•Push in the pin in the floor attachment as shown in the illustration at right.

•Insert the floor brush into its location, in the direction

of the arrow.

•When inserted correctly, the pin will show in the pin hole.

Hole

ON/OFF SWITCH

•The On/Off switch has two different positions.

•Push on the "I" side to turn the vacuum ON.

•Push on the "O" side to turn the vacuum OFF.

=OFF

=ON

•Unwind the power cord and plug into the 120V outlet.

•Push down in the direction of the arrow to obtain best results on carpets or on hard wood floors.

NOTE: When vacuuming deep pile carpets or hard to vacuum carpets, lower the angle of the 2-piece metal handle

(see illustration at below) for easier maneuverability.

USING THE UNIT AS A HAND VACUUM

•Disconnect the metal handle. (See page 4.)

•Disconnect the floor brush. (See page 4.)

•Attach the hose. (See page 4.)

•Attach the crevice tool or the dusting brush. (See below.)

•Attach the shoulder strap. (See page 7.)

•	Hold the dust cup in your hand and
	remove the HEPA-Type dust cup filter
	(see drawing #4).
•	Empty the dust cup (see drawing #5).