GETTING TO KNOW YOUR SHARK TURBO STICK VAC
OPERATING INSTRUCTIONS cont.
Technical Specifications
Voltage: | 120V., 60Hz. |
Power: | 7.5 Amps, 900 Watts |
2
Replacing The Dust Cup Into The Unit
•Hold the dust cup in your hand.
•Make sure that the slot on the bottom of the cup is pointed in the same direction as the pins in the unit (see drawing #1).
•Slide the dust cup inside to the end of its place in the unit (see drawing #2).
•Turn the dust cup 90° in the direction shown in the drawing (#3) at right.
•The unit is now ready to be used again.
Note: To keep the vacuum cleaner looking new, it can be wiped with a damp cloth and a mild soap solution, then thoroughly dried. Never use any type of chemical cleaners as they can damage the vacuum cleaner. When not in use, store the vacuum cleaner in a dry, clean place.
7
Attaching the Shoulder Strap
Use the hooks to attach the shoulder strap to the vacuum cleaner.
Connect the dog leash swivel hooks to the eyelets located near the top of the unit handle and at the base of the unit. Adjust the strap as required for comfort.
Hook for | Hook for |
Shoulder | Shoulder Strap |
Strap |
|
Warning: After extended use, the body of the vacuum cleaner may become hot. When using the unit with the shoulder strap, the unit will touch the body of the user. Therefore make sure to use the vacuum cleaner with the strap only when the unit is cool. If it gets too warm, allow it to cool before continuing to use it.
Motor Thermostat
IMPORTANT: This unit is equipped with a motor protective thermostat. If for some reason the vacuum cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur:
•Push the On/Off button once.
•Disconnect the plug from the power source.
•Check the source of overheating problem. (i.e. clogged hose or filter).
•If clogged hose or filter is found, unclog the hose and replace the filters.
•Wait at least 45 minutes before attempting to reuse the vacuum.
•After unit has cooled down for
45 minutes, plug in the cleaner and push the On/Off button. The vacuum should start again.
•If the vacuum still does not start, contact customer service at