Sears 12681 Shell Stitching Models 12781 Smocking, Set the Machine Stitch Stitch selector

Page 36

SECTION 3. LEARN THE STITCHES

Shell Stitching (Models 12781 and 12681)

Smocking

Set the Machine

Stitch

Stitch selector

Set the Machine

Stitch

Stitch selector

Top thread tension	Stitch length
control 3 to 9	control 1to 2

Zigzag foot

The Stitch and Its Uses

The Shell Stitch is formed by sewing a blind hem over folded fabric. Several

rows of shell stitching are called shell tucks.

Shell stitching can be used to finish hems, sleeve and neck openings.

Shell _cking can be used to create

scalloped tucks on blouses and

lingerie.

Here's How

1.For best effect:

-set the stitch length as you desire.

--you may need to tighten the top thread tension slightly.

- allow the needle to just clear the folded edge of the fabric when it zigzags.

2.If you sew rows of shell stitches, space the rows 1/2" apart.

You can sew Shell Stitch on knits or soft silky wovens in any direction.

Top thread tension Stitch length control

control 1 to 4 yellow stretch stitch position

Zigzag foot

With the stitch length at "4", sew

straight stitching lines 3/8" apart across the area to be smocked.

Knot the threads along one edge, Pull the bobbin threads and distribute the

gathers evenly. Secure the threads at

the other end. Sew the decorative stitch between the gathering stitches. Pull out the ga_ering stitches.

NOTE: Loosen the top thread

tension to make gathering easier.

32

Image 36

Contents Sewing Machine SEARS, Roebuck and CO Kenmore Sewing MachineImportant Safety Instructions Operating Instructions Table of Contents Portable Case or Cabinet is Available Locate and Identify the PartsFace Cover Plate Identify the Accessories AutoClutchKnobFoot Control Use ChildrenSetting Spool Pin Adjust the Presser Foot Lever Thread CutterSeveral Section Prepare Your Machine for Sewing ExtensionTableFabric, Needle, Thread and Stitch Length Chart TtmdGreen For Check Your NeedleTo Remove the Bobbin Case from the Machine Wind the BobbinPull 3 to Latch Bobbin as shown BobbinThread Your Needle Bring bobbin thread up by pulling Top threadOoI!t LoosePrepareyourmachineforsewing Top tension Too Tight Too Loose Just RightPrepare Your Machine for Sewing Stitch SelectorStitch Length Control Adjusting Stretch Stitch Balance Reverse Stitch ControlReleaseto sew forward again StartingTo Sew Now that you are familiar Kenmore sewing machineLearn the Stitches Use the Seam GuidesTurn a Square Corner Straight Stitches Usethe DarningPlate Darning Straight StretchBe usedo et! f= csand Zigzag Stitches BasicZigzag Satin Stitch Heres HowZigzag Stitches Applique Bar TackingSew 4 to 6 zigzag stitches Sew a Button To strengthen the shank, cutSection Learn Stitches Zigzag Stitches Overcasting Stitch Rick-Rack StretchThis zigzag variation is very useful HeresHow Place the fabric under the presserFoot so that the stitches are made Overcast Stretch Stitching Models 12781, 12681Zigzag Stitches Lace Work Models 12781, 12681Three-Step Zigzag Stitch and Its UsesBlind Hemming Models 12681Stjtch That Be*wcon exteRded=edeButtonholes Stitch selectorTop thread tension Stitch length contro control 1 to5 Set the stitch selector at b. Sew 4 to 6 stitches Sew in a Zipper Per, set the zipper foot Right side of the needleStitch across and below Tom of the zipperShell Stitching Models 12781 Smocking Set the Machine Stitch Stitch selectorTop thread tension Stitch length Control 3 to Control 1to Set the stitch length as you desireElastic Stretch Stitch Model 12781 only Box Stitching Model 12781 onlyPosition Top thread tension Stitch Length Control 1 toWhat to Do When Check bobbin case threading Clean bobbin caseand shuttle What to Do WhenSkipping Stitches Breaking Upper Thread Fabric not MovingCleaning the Machine Care for YourReplacing the Light Bulb MachineClean the Shuttle Race Occasional tangled thread. Clean the shuttle race areaAbout every three months Oiling the Machine Oil points in illustrationParts List Ref. NoShuttle InstructionsIndex ExtensionZipper application 3031 Memo Memo Warranty SEARS, Roebuck and CO., D/817 WA, Hoffman Estates, IL