Sears 11682, 12781, 12681, 12581 manual Important Safety Instructions

Page 3

IMPORTANT SAFETY

INSTRUCTIONS

Your sewing ma(_hineis designed and constructed only for HOUSEHOLD use. Read all instruction before using this sewing machine.

DAN G ER- Toreduce the risk of electric shock:

1.An appliance should never be left unattended when plugged in. Always unplug this appliance from the electric outlet immediately after using and before cleaning.

2.Always unplug before relamping. Replace bulb with same type rated 15 Watts.

3.Do not reach for the appliance that has fallen into water. Unplug immediately.

4.Do not place or store appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid.

or injury to persons.

1, Do not allow to be used as a toy. Close attention is necessarywhen this appliance is used by or near children.

2, Use this appliance only for its intended use as described in this manual. Use only attachments recommended by the manufacturer as contained in this manual.

3.Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to the nearest authorized dealer or service center for examination, repair, electrical or mechanical adjustment.

4.Never operate the appliance with any air opening blocked. Keep ventilation openings of the sewing machine and foot controller free from accumulation of lint, dust, and loose cloth.

5.Never drop or insert any object into any opening.

6.Do not use outdoors.

7.Do not operate where aerosol (spray) products are being used or where oxigen is being administered.

8.To disconnect, turn all controls to the off ("O") position, then remove plug from outlet.

9.Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

10.Keept fingers away from all moving parts. Special care is required around the sewing machine needle.

11.Always use the proper needle plate. The wrong plate can cause the needle to break.

12.Do not use bent needles.

13.Do not poll or push fabric while stitching.

tt may deflect the needle causing it to break.

14.Switch the sewing machine off ("O") when making any adjustment in

:_,_

_

foot, and _ I_=ke;

15.Always unplug the sewing machine from the electrical outlet when removing covers, lubricating, or when marking any other user servicing adjustments mentioned in the instruction manual.

SAVE THESE INSTRUCTIONS

Image 3
Contents Sewing Machine Kenmore Sewing Machine SEARS, Roebuck and COImportant Safety Instructions Operating Instructions Table of Contents Portable Case or Cabinet is Available Locate and Identify the PartsFace Cover Plate AutoClutchKnob Identify the AccessoriesChildren Foot Control UseSetting Spool Pin Adjust the Presser Foot Lever Thread CutterSeveral ExtensionTable Section Prepare Your Machine for SewingCheck Your Needle Fabric, Needle, Thread and Stitch Length ChartTtmd Green ForWind the Bobbin To Remove the Bobbin Case from the MachineBobbin Pull 3 to Latch Bobbin as shownThread Your Needle Top thread Bring bobbin thread up by pullingLoose OoI!tTop tension Too Tight Too Loose Just Right PrepareyourmachineforsewingPrepare Your Machine for Sewing Stitch SelectorStitch Length Control Adjusting Stretch Stitch Balance Reverse Stitch ControlReleaseto sew forward again Now that you are familiar Kenmore sewing machine StartingTo SewLearn the Stitches Use the Seam GuidesTurn a Square Corner Straight Stitches Usethe DarningPlate Darning Straight StretchBe usedo et! f= csand Zigzag Stitches BasicZigzag Heres How Satin StitchZigzag Stitches Applique Bar TackingSew 4 to 6 zigzag stitches To strengthen the shank, cut Sew a ButtonSection Learn Stitches Zigzag Stitches Overcasting Stitch Rick-Rack StretchThis zigzag variation is very useful Overcast Stretch Stitching Models 12781, 12681 HeresHowPlace the fabric under the presser Foot so that the stitches are madeStitch and Its Uses Zigzag StitchesLace Work Models 12781, 12681 Three-Step ZigzagThat Be*wcon exteRded=ede Blind Hemming Models12681 StjtchButtonholes Stitch selectorTop thread tension Stitch length contro control 1 to5 Set the stitch selector at b. Sew 4 to 6 stitches Sew in a Zipper Tom of the zipper Per, set the zipper footRight side of the needle Stitch across and belowSet the stitch length as you desire Shell Stitching Models 12781 SmockingSet the Machine Stitch Stitch selector Top thread tension Stitch length Control 3 to Control 1toTop thread tension Stitch Length Control 1 to Elastic Stretch Stitch Model 12781 onlyBox Stitching Model 12781 only PositionWhat to Do When Fabric not Moving Check bobbin case threading Clean bobbin caseand shuttleWhat to Do When Skipping Stitches Breaking Upper ThreadMachine Cleaning the MachineCare for Your Replacing the Light BulbClean the Shuttle Race Occasional tangled thread. Clean the shuttle race areaAbout every three months Oil points in illustration Oiling the MachineInstructions Parts ListRef. No ShuttleIndex ExtensionZipper application 3031 Memo Memo SEARS, Roebuck and CO., D/817 WA, Hoffman Estates, IL Warranty