Tap Installation
C.Using a crossover cable, connect one end to the Switch’s port configured to be the destination port of the Port Mirror.
If adding a Threat Analysis Reporter to an existing installation, this port would be the port that was originally occupied by the listening interface of the R3000.
D.Connect the other end of the crossover cable to the Ethernet Tap’s Network A port.
Ports in front panel of NetOptics 10/100BaseT Tap
E.Using a straight through cable, connect one end to the Ethernet Tap’s Network B port.
F.Connect the other end of the straight through cable to the R3000’s listening interface.
G.Using the second straight through cable, connect one end to the Ethernet Tap’s Monitor A port.
H.Connect the other end of the second straight through cable to the Threat Analysis Reporter’s listening interface.
Proceed to Step 2: Wizard Setup Procedures of the Threat Analysis Reporter installation instructions.
8e6 Threat Analysis Reporter Quick Start Guide | 69 |
