Sears 385.16631 owner manual Overlock Uses standard Kenmore

Edge of needle bar

_4eedle clamp \

Needle clamp screw on the left

£3 screw

• on tne right

®

J

(_ Disconnect the machine from the power supply.

Raise the needle to its highest position. Then loosen the needle clamp screw for the needle you are goin£ to remove.

Refer to page 24 for changing the needle

for three-thread serging.

screw_/J_'PmNeedleneeas[ooOerolbareEdge\

xNeed[e.g,.

	clamp-_	!	_
Flat siae	_Needle
to the back

1

I * Correct needle setting]

To Attach the needle on the right

nsert new needle into the needle clamp with the flat side to the back until the top of needle touches the stopper pin, then tighten the needle clamp screw on the right.

To attach the needle on the eft

Insert new needle into the needle clamp with the flat side to the back until the top of needle touches the edge of needle bar. then tighten the needle clamp screw on the left.

When	the needles	are	set correctly,	tne left	NOTE: Your	overlock	uses standard Kenmore
needle	is higher than	the	right one.		sewing	needles	(HA-1 SP, #11, #14).

No special needles are required.

Do not use any needle which is bent or blunt•

28