Kenmore 385. 17622 owner manual Foot control is sensitive, Foot Control Use

Page 7

Set Up the Machine

Plug in the Machine and Switch on the Power

SECTION 2. PREPARE THE MACHINE FOR SEWING

•Foot Control Use

Plug connector

Machine plug

J

NOTE: Before inserting the plug into your

machine, be sure the power switch is OFF.

light

4.Push the light and power switch to turn on the power and sewing light.

SAFETY FEATURE:

Your machine will not operate unless the

light/power switch is turned on. If you are

interrupted or stop sewing, turn off the

Foot control

The foot control regulates the speed at which you saw,

To increase speed, gently press down with the ball of your foot.

To decrease speed, release your foot pres- sure slightly.

light/power switch to prevent injury to children,

NOTE:

The foot control is sensitive and

1.Check your outlet to be sure it is a 110 to 120 Volt AC outlet.

2.Insert the machine ptug into the three-prong

plug connector, as shown. It will only fit one way.

3, Insert the power supply plug into the outlet.

OPERATING INSTRUCTIONS

"For appliances with a polarized plug (one blade wider than the other).

To reduce the risk of electric shock, this plug is intended to fit in a

polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install

the proper outlet. Do not modify the plug in any way."

"Foot Controller Model YC-482P for use with Sewing Machine Models

wilt increase'or decrease your

sewing speed immediately.

Practice on a scrap of fabric to

regulate your sewing speed to

your taste and needs.

385.1148xxx, 385.1158xxx, 385.1168xxx, 385.1258xxx, 385.1268xxx,

385.12612 x x x, 385.1278x x x, 385.11607x x x, 385.12710× x x, 385.12TI4x x x, 385.12712xxx, 385.17622xxx, 385.11608xxx, 385.12814xxx and 385.12014xx×.

x xx - represents numbers 000 through 999." (For U.S.A. market only)

100-316-0055

Image 7

Contents Sewing Machine Kenmore Sewing Machine SEARS, Roebuck and COSewing machine Keep Table of Contents Locate and Identify the Parts Portable Case or Cabinet is AvailableIdentify the Accessories Foot Control Use Foot control is sensitiveAdjust the Presser Foot Lever Thread Cutter Choose Needle and Thread Section Prepare Machine for SewingTo Changethe Needle Stretch Clutch knob inside the hand wheel Winding Wind the BobbinThread EndPrepare the Top Thread Thread the Needle Presser Pick Up the Bobbin ThreadHold top Adjust the Top Thread Tension To reverse stitch, hold down this control during Reverse Stitch ControlRelease to sew forward again Built-in Stitch SelectorRaise the needle to its highest position Length controlStitch Length Control Adjusting Stretch Stitch Balance=H--1-1-3-,- !t lJ Preparethe Machineforsewing Straight Stitches Stitch selector Left Needle PositionTopstitching Zigzag footStitch length Stitch selector control Control 3 to Fold back the left seam allowance As shownSew in a Zipper Set the Machine StitchInvisible Zipper and Cording Between embroidery hoops with hole PutPlate Needle plate Remove presser foot and stretch fabricZigzag Stitches Edge of the applique Section Learn StitchesSure FallsSew about five stitches and raise needle Sew a ButtonZigzag Stitches Overcasting Stitch That the stitching will catch both sides Zigzag Stitches Three-Step ZigzagSelector retease Can Section Learnthe StitchesTrim excess fabric close to stitching Called ShetlBox Stitching Set the Machine Green zone Fagoting StitchDecorate with Geometric Patterns Set the Machine Selector release Stitch lengthRick-Rack Stretch Stretch Stitches StraightStretchRaveling With the stitch length at 4, sewEffectively Prevents Fabric NeedleSkipped stitches From Edge Herring Bone Stretch Decorative Stretch PatternsSt=tch SelectorButtonholes Sewing at Machine Jamming Knocking Noise Breaking Bobbin ThreadCheck bobbin Lint in bobbin case or shuttleChoose correct size needle for thread and fabric When starting a seam be sure to draw both threads underWhat to Do When Nicks or burrs at hole of needle plateClean the Feed Dogs Replacing the Light Bulb Cleaning the MachineUnplug Lever Oiling the Machine Parts List Index Adjusting stretchAppear WarrantySEARS, Roebuck and CO., D/817 WA, Hoffman Estates, IL SEARS, Roebuck and CO., Chicago, IL60684 U.S.A Sewing MachineBrown PosITION Stitch SelectorSurplus oil is absorbed Brown pOS T onWhich may cause Noise or Jamming TensionBorroM Threading Dogs to remove accumulated dust and lintSewing Machin E Part Description Optional Feet and Attachment Sewing Machine Source Model noOrtant