Setting up the sewing computer | 13 |
Bobbin case
A
To remove the bobbin case | To insert the bobbin case | Bobbin thread cutter | Refer to the safety | |
• raise the needle | • hold the bobbin case latch | • | insert the bobbin case | instruction! |
• turn power switch to «0» | • the finger on the case should | • take the thread over cutter A |
| |
• open the bobbin cover | point upwards | • | thread is cut |
|
• grasp the latch of the bobbin | • insert so that it clicks into | • | close the bobbin cover |
|
case | place |
|
|
|
• remove case |
| Note: |
| |
|
| The bobbin thread does not |
| |
|
| have to be brought up as |
| |
|
| the loose end is just the right |
| |
|
| length to start sewing. |
|
030529.52.04_0303_a135 a145_EN