Desa SVYD18NRA/PRA SERIES Manual Lighting Procedure, Optional HAND-HELD Remote Operation

OPERATING HEATER

Continued

MANUAL LIGHTING

PROCEDURE

1. Follow steps 1 through 6 under Lighting In- structions, page 15.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 sec- onds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11 under Lighting Instructions, page 15.

OPTIONAL HAND-HELD

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page 27). Follow instructions included with the remote control.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions on pages 14 and 15.

1. After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob any- where between HI and LO. Slide the selec- tor switch to the REMOTE position (see Figure 22). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

Flame Adjustment Knob

	IH		PIL
ON		F	OT
		O F	O
OFF
			N
REMOTE	LO
Remote Selector Switch in	Control Knob
REMOTE Position	in ON Position
(Optional Remote Control)

Figure 22 - Setting the Remote Selector

Switch, Control Knob, and Flame

Adjustment Knob for Remote Operation

ON/OFF SERIES (MODEL GHRCB)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 23).

TO LOCK press both buttons on hand-held re- mote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

TO UNLOCK press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now un- locked.

Control Button

Turns Burners

On and Off

Figure 23 - On/Off Hand-Held Remote

Control Unit (GHRCB)

THERMOSTAT SERIES (MODEL GHRCTB)

The hand-held remote can be operated using either the manual mode (MANU) or thermo- static mode (AUTO) (see Figure 24). To select Fahrenheit/Centigrade mode display, carefully press the ˚C/˚F mode button with the end of a paper clip or similar blunt object.

Manual Mode

1.Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2.Press the MANU button to turn on the heater.

	Turns
Digital Display	Remote On
	or Off and
Shows	Allows You
Temperature	to Choose
and Settings	the Manual
Turns Burners	Setting
On or Off	Selects Auto
Decreases	Setting
Room	Increases
Temperature	Room
in AUTO Mode	Temperature
Locks System to	in AUTO
Prevent Accidental	Mode
Ignition

Figure 24 - Thermostat Hand-Held Remote Control Unit (GHRCTB)

16 www.desatech.com 113084-01A