Drolet DB03110, DB03115, DB03116 owner manual Safety Information

Page 36

3.1SAFETY INFORMATION

These stoves are designed for safe operation WHEN BURNING WOOD ONLY. Altering or modifying the unit or installation without proper authorisation will void the certification, warranty, and safety listing, and may result in a safety hazard.

For safety reasons, never leave the unit unattended with the door open or ajar. An open door, and especially a door partially open or cracked, if left for longer than required for good ignition can potentially result in unsafe chimney temperatures, and if left unattended, in hot embers or ignited fuel falling out of the unit. Prolonged door open operation is not necessary provided the unit has been properly installed and dry kindling is used to start the fire.

Do not abuse the unit, either by over firing or by using wood or combustibles with salt content, or harmful chemicals. Misuse is not covered by warranty.

Even though your E.P.A Drolet stove has been specifically designed and tested to prevent smoke spillage, always open the door slowly as this will minimise the likelihood of smoke spillage or a back draft of flame or smoke into the room.

Never use gasoline type lantern fuel, kerosene, solvents, charcoal lighter fluid, or inflammable liquids to start or "refresh" a fire in the stove. Keep all such liquids well away from the stove while it is in use.

All stove surfaces become very hot during operation. Care is needed, especially with children, to avoid contact with those surfaces.

Do not elevate the fire by means of grates.

CAUTION: DO NOT OVER FIRE THIS HEATER. Do not burn fuel in the stove at a rate higher than that which will cause the ember bed level to exceed half the door opening height. We strongly recommend that you purchase a chimney (flue) thermometer. There are two types of thermometers: probe thermometers and magnetic thermometers (the later is also called

“stove top thermometer”). If you are using a probe thermometer, make sure that the temperature does not exceed 900oF (482oC). If you are using a magnetic thermometer, make sure that the temperature does not exceed 475oF (246oC). If the door handle of the stove becomes excessively hot to the touch, consider this to be an indication of over firing. Over firing can result in a safety hazard and can permanently damage the stove and chimney. This damage is not covered by the warranty.

Image 36
Contents Escape 1800 EPA Wood Stove Models DB03100, DB03110, DB03115, & DB03116Introduction Table of Contents Specifications Drolet Limited Lifetime Warranty Installation General InstallationLegs and ash drawer assembly for DB03116 model Page Positioning the Stove ClearancesSee .3 on the following Clearances to combustible materials Reduced Clearances Type of ProtectionGraphic Graphic Graphic Floor Protector Floor protectorTips on Wood Heating Chimney Flue System DefinitionsChimney Page Wall support system ChimneyStove pipe 1 a Typical installation through the wall Typical installation through the wallPage Page Page Typical installation through the ceiling Ceiling support systemPage Page Page 2 a Typical Installation Through an Existing Masonry Chimney 2 B Factory Built Thimble 2 C Brick Thimble Chimney Connector A Connecting Sections Draft Advantage of Installing a Blower FAN Outside Combustion AIRPage Operation Keep these instructions for future referenceSafety Information Fuel Energy yield for wood species Use of manufactured logs Wood species Energy yield Millions of BTU/cordSimple wood moisture test Lighting a FireIntensity Draft Setting Maintaining the Fire FAN Blower OperationMaintenance Cleaning and Painting Your StoveGlass ASH Removal Using the ASH Drawer GasketingChimney Flue Cleaning Baffle Installation for Escape 1800 ModelVermiculite Baffle Secondary AIR Tube Replacement Important NotesFront 41 holes of 5/32 Section Specifications Drolet Limited Lifetime Warranty Description