Enviro Enviro Maxx owner manual Post Season CLEAN-UP, Cleaning Painted Surfaces, Firebox Liner

Page 12

Routine Cleaning and Maintenance

EXHAUST VENT (Biannually)

This vent should be cleaned every year or after two tons of pellets. We recommend contacting your dealer for professional cleaning. To clean the vent pipe, tap lightly on the pipe to dislodge any loose ash. Open the bottom of the “T” to dump the ash, then vacuum as much of the ash out of the vent pipe as possible.

FRESH AIR INTAKE (Biannually)

Inspect periodically to be sure that it is not clogged with any foreign materials.

BLOWER MECHANISMS (Annually)

Unplug the stove then open the right and left side panels to access the two blowers. Remove the two (2) T-20 Torx screws on the back of the each panel. Pull the bottom of the panel out then slide the top of the panel down off the tab. Vacuum all dust from motors. The blower motors’ has sealed bearings, DO NOT lubricate this motor. Check gaskets and replace if needed.

POST SEASON CLEAN-UP

Once you are finished using the pellet appliance for the season, unplug the stove for added electrical protection. It is very important that the stove be cleaned and serviced as stated above.

CLEANING PAINTED SURFACES

Please clean painted surfaces with a soft damp cloth.

FIREBOX LINER

The paint on the Firebox Liner may peel. This is due to extreme conditions applied to the paint and is in no way covered by warranty.

DOOR GLASS REPLACEMENT

It is recommended that your dealer replace the glass if broken. The door glass is made of high temperature PYRO CERAMIC. To replace the glass, unscrew and remove the four (4) retainer nuts 7/16” socket. Remove the two (2) T-20 screws holding the inner door to the glass retainer. Remove the glass and any broken pieces. High temperature fiberglass tape should be used around the glass in the same location as the original fiberglass. Insert the glass into the retainer, screw the inner door to the retainer, install inner door assembly into outer door and gently tighten nuts. The use of substitute materials is prohibited: Small Glass (9” x 25⁄8” [229mm x 60mm]); 50-1061 or Large Glass (9” x 13” [229mm x 330mm]); EF-061.

12

Image 12
Contents Enviro Maxx Table of Contents Introduction Store pellets at least 36 1 m away from the pellet stoveSafety Warnings & Recommendations Safety Warnings & Recommendations Dimensions of Maxx Maxx Specifications Operating InstructionsUnit Overheated Circuit Board Control Panel DecalManual Mode To Start Press the on / OFF button. The stove will turn onSpecial Notes Slider/Damper Plate in UnitRoutine Cleaning and Maintenance Tools Required to Clean UnitHeat Exchanger Tubes Weekly Door Glass Cleaning Weekly ASH PAN and Door Gaskets WeeklyASH BOX Weekly Do not Place Unburned or RAW Pellet Fuel in ASH PANPost Season CLEAN-UP Cleaning Painted SurfacesDoor Glass Replacement Firebox LinerWarranty To the DealerTo the Distributor Exclusions and Limitations Warranty Installation Data Sheet Name of Owner Address