Harman Stove Company 929 DV manual Assembly, Removing the Glass Front

Page 7

ASSEMBLY

The Clarity is shipped from the factory with the log set packed inside the firebox. To prepare the stove for installa- tion, the log set must be unpacked, the appropriate burner system module for either natural gas or propane installed, and the logs installed.

Removing the Glass Front

NOTE: The glass front is heavy. Be prepared for its weight when lifting it to avoid damage during removal.

The wing doors on each side are held closed by mag- nets. Push on each door to open it. Loosen the wing nut on each of the two spring-loaded levers. Grasp each lever and push to the rear to disengage the front. To keep the levers in the disengaged position, tighten the wing nuts. Lift the glass front slightly and remove it from the stove. Set the glass aside in a safe place where it will not be damaged.

Remove and Unwrap the Log Set

As shown in the photo in the right column, the log set consists of a back log (1), a center log that has a pilot-view- ing port in the left end (2), two ember strips (3), and a branch that rests on top (4).

In addition, there are two side brick panels and a back brick panel.

The log set components are shipped from the factory individually wrapped and packed inside the stove. Take them out of the stove, then carefully remove the wrapping. Handle the logs gently as they may be damaged easily.

1

 

2

3

4

3

The front is released when spring-loaded levers on the left and right sides are pushed to the rear

WARNING: Do not abuse the Clarity's glass by striking, slamming, or similar trauma. Do not operate the Clarity Gas Heater with the glass panel removed, cracked or broken. Use only glass supplied by Harman and approved for use with this heater. Do not use substitute materi- als. Replacement of the panel should be done by a licensed or qualified service person.

Installing the Burner System Module

The burner system module may be installed into the fire- box as an integrated unit, and it may help to have an assistant who can assist in guiding the components into position and in making sure that themodule does not siton any wiring compo- nents.

Hold the module at a slight angle, then lower it through the opening and rotate upright until it is in position.

Reach underneath and install one of the wing nuts, finger tight. Then check to see that the module is seated correctly.

A sealing gasket affixed to the bottom of the module's base plate will cause the log support plate to be elevated slightly above the plane of the firebox bottom plate. When the two wing nuts are tightened, this gasket will be compressed and a correct fit will be indicated by thelog support plate becoming flush with the bottom of the firebox.

Install wing nut

 

on threaded stud

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Harman Clarity 929 DV Direct Vent Gas Stove Contents Introduction Installation of the Clarity Direct Vent Gas HeaterImportant Notice InstallationClearances Use Only Approved Venting VentingHorizontaland Vertical Venting Requirements Addition, the following must be observed Connecting To An Existing ChimneyVersion kit #934 Removing the Glass Front AssemblyInstall the Center Log Installthe BranchInstallthe Side Brick Panels Install the Ember StripsGas Pressure Requirements Connecting the Heater to a GAS SupplyBurn Only the Fuel for which the Heater is Equipped Making The ConnectionConnecting the Cordset Connecting the Heater to CordsetConnecting the Optional Thermostat AIR Shutter Adjustment AIR Shutter AdjustmentMonitoring the Gas Flame HOW to Turn OFF the Fire HOW to Light the FireOperation SAFETY/LIGHTING Label Replacing the Gasket MaintenanceCleaning the Glass Cleaning the Log Set and FireboxWiring Diagram ID# Part No Parts ListClarityPARTSParts Clarity Burner Module Exploded View Minimum Clearances from Combustible Construction SpecificationsUnplug the Cordset Remove the Glass Front Unplug the Electrical ConnectorsAppendix a Conversion Kit ComponentsAltitude Injector Input Rate Appendix BDe-rating for High Altitude Front Harman Center Rear4DT -CSS 6-5/8 and 5 X Secure Vent Direct Vent SystemDirect Vent GS Harman Gold Warranty Harman Gold Warranty

929 DV specifications

The Harman Stove Company 929 DV is a modern marvel in the world of heating appliances, bringing unmatched efficiency and performance to homes. Known for its commitment to quality, engineering, and innovation, Harman has established itself as a leader in the manufacture of wood, pellet, and gas stoves. The 929 DV model is specifically designed to enhance the heating experience while ensuring a beautiful aesthetic appeal.

One of the standout features of the Harman 929 DV is its direct vent technology. This innovative system allows for venting through an outside wall, using two pipes – one for exhaust and one for fresh air intake – which significantly improves efficiency. This setup not only ensures that your indoor air quality remains optimal but also provides flexibility in installation options, making it suitable for various home designs.

The 929 DV is equipped with a powerful burner that delivers an impressive heating capacity, capable of warming spaces sized up to 1,900 square feet. Its adjustable heat output makes it suitable for different needs, ensuring that the space remains cozy even during the coldest winter months. The unit features a user-friendly digital control panel, allowing homeowners to easily adjust the temperature settings, air intake, and blower speed for personalized comfort.

In terms of build quality, the 929 DV boasts robust construction, employing high-quality materials that ensure longevity and durability. The stainless steel and cast iron components add a touch of elegance while enhancing overall performance. Harman’s commitment to user safety is evident in the model’s advanced safety features, including an automatic shut-off mechanism and a sealed combustion chamber that minimizes the risk of hazardous emissions.

Aesthetically, the Harman 929 DV is designed to complement various interior styles, featuring a sleek, contemporary look with large glass doors that provide a beautiful view of the flames. This is accentuated by a variety of finishes available, ensuring a perfect match for any decor.

With its combination of efficiency, safety, and modern design, the Harman Stove Company 929 DV stands out as a top choice for homeowners seeking a high-quality heating solution. Whether you are looking to heat a space or simply add a focal point to your room, the 929 DV offers something for everyone, making it a worthy investment for the modern household.
Top Page Image Contents