To Light, Attach propane cylinder, Leak Check

To Set Up cont.

Attach propane cylinder

■Make sure burner valve is turned to off position.

■Check the connection between the cylinder and the regulator with soapy water. Bubbles indicate a leak. Never use a flame. Check that the connection is not cross-thread- ed and that it is tight. Perform another leak check. If there is still a leak, remove the cylinder and con- tact Coleman for service or repairs.

To Light

DANGER

•EXPLOSION - FIRE HAZARD

•Propane is heavier than air and can accumulate in low places. If you smell gas, leave the area immediately.

•Always attach or detach propane source outdoors; never while stove is lighted, near flame, pilot lights, other ignition sources or while stove is hot to touch.

•This stove is red hot during use and can ignite flammables too close to the burners. Keep flammables at least 12 inches from the sides and 48 inches from the top of the stove. Keep gasoline and other flammable liquids and vapors well away from stove.

■Remove plastic cap from top of propane cylinder and screw propane cylinder into REGULATOR hand tight.

■Set on sturdy, flat area. For outdoor use only.

■Insert lighted match through hole in GRILLING SURFACE and open

BURNER VALVE.

■Adjust flame with BURNER VALVE.

■Flame should be blue with hint of yellow on tips.

Leak Check

■Make 2-3 oz. of leak check solu- tion (one part liquid dishwashing detergent and three parts water).

CAUTION

•SERVICE SAFETY

Keep all connections and fittings

clean. Inspect propane cylinder and stove propane connections for damage before attaching.

During set up, check all connec- tions and fittings for leaks using soapy water. Bubbles indicate a leak. Never use a flame.