OPERATING INSTRUCTIONS
READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY.
WARNING
•DO NOT allow gasoline or other flammable vapors or liquids to come in contact with stove while lighting or at any time during use of stove.
•DO NOT allow the gas hose to come into contact with any hot surfaces. Inspect the hose for damage such as burns, chafing, and kinks before each use.
Step 1
Make sure "Gas Leak Testing" from page 4 was completed and the burner control knobs are in the "OFF" position and stove is on a flat surface away from combustible material.
Step 2
Decide which burner to light first. Using a long match, hold the flame beside burner. Turn the burner control knob SLOWLY
WARNING: If the burner does not light within 5 seconds, turn the burner control knobs "OFF" immediately. Wait at least 5 minutes until gas fumes have dissipated before attempting to light burner again.
Step 3
To light the second burner, reduce the flame on the first lit burner and repeat Step 2 to the other burner.
WARNING: If second burner does not light within 5 seconds, turn the burner control knobs "OFF" immediately. Wait at least 5 minutes until gas fumes have dissipated before attempting to light burner again.
Step 4
Adjust burner flame as necessary by using burner control knob. Turn stove "OFF" using burner control knobs when stove is not in use.
Step 5
Allow stove to cool completely, then follow instructions in the
Minimum clearance to
combustibles 36 inches from top
and side of stove burners
36"
36"
Perimeter of base of stove
ON / Larger Flame
OFF / Smaller Flame
NOTE: Observe flame height and color when lit. Flame should have a blue center and yellow tip.
Burner 
Yellow
Blue
5