6
INSTALLATION
COMBUSTION AIR SUPPLY
For a mobile home installation the stove must be connected to an outside source of combustion air. A 2” inside diameter metallic pipe, either flexible or rigid, may be attached to the inlet at the stove’s rear (refer to figures 5 & 6). A rodent guard (minimum ¼” wire mesh)/wind hood must be used at the terminus (refer to figure 7). All connections must be secured and airtight by either using the appropriately sized hose clamp and/or
For mobile home installations only: 2” inside diameter pipe may be used for the first 5 feet of combustion air supply run. From 5 to 10 feet use 2 ¾” inside diameter pipe. No combustion air supply may exceed 10 feet.
Sources of Outside Combustion Air
a.In fireplaces
∙Chimney top.
∙Ash clean out door.
b.For freestanding installations
∙A hole in floor near stove rear terminating only in a ventilated crawl space.
∙A hole in the wall behind the stove.
WHEN OUTSIDE AIR IS NOT USED
If outside air is not used, it is important that combustion air is easily available to the air inlet. A closeable outside air register can be used in tightly insulated homes. In insert installations, flashing vents should not be restricted. The flashing should not necessarily seal the fireplace face.
VENTING
The Breckwell P2000 Freestanding is certified for use with listed TYPE
The Breckwell P2000 Insert is certified for use with listed TYPE L- Vent, stainless steel single wall pipe, or stainless steel flex pipe 3” or 4” diameter in size.
This is a pressurized exhaust system. All vent connector joints must be sealed with 500°F (260°C) RTV silicone sealant to ensure consistent performance and avoid smoke spillage. All horizontal connector joints must be sealed with
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE.
DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT.
INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER.
REAR VIEW P2000FS
FIGURE 5
REAR VIEW P2000I
FIGURE 6
FIGURE 7