ADDITIONAL SAFETY RULES
1.Use only 12 volt DC power source, or the motor will be damaged.
2.Operate the tool only after removing mud and sand from the car body and sponge, or the car body will be scratched by mud and sand.
3.Do not wet the tool, or the tool will be damaged.
4.Do not bear down the tool excessively during operation. Smooth and even operation cannot be performed because the bottom of the sponge will not move correctly as designed.
5.Do not place the tool directly on the ground. Mud and/or sand may stick to the sponge and scratch the car body.
6.Do not place the tool on the car body, the tool may fall from the car body and be damaged or cause damage to the car. Use the plastic case as explained on page 6.
7.Do not leave the tool in hot places such as a car exposed to direct sunlight and with the doors and windows closed. This can cause discoloration andlor damage to the tool enclosures.
8.Wipe the tool off with a soft cloth dampened in detergent solution. Never use thinner or benzine. This can cause discoloration and cracks in the tool enclosures.
9.Let the engine of the car idle to maintain the charge in the car's battery when using the tool for a long time.
SAVE THESE INSTRUCTIONS.
4