Sony Ericsson Bluetooth Enabled Hands-Free Kit /Headset specs

1.Press the Menu button. Scroll to Connect., OPTIONS. A list of options will be displayed. Choose OPEN then press SELECT. Choose Bluetooth, OPTIONS. Choose OPEN, and

press SELECT.

2. Bluetooth OFF will be displayed. Press OPTIONS. Change, SELECT. Choose On, then press OK.

3.Continue pressing Exit key to exit the Menu.

b. PAIRING TO THE CELLULAR PHONE

1.Bring the cellular phone at about 20 cm from the headset.

2.Detach the headset from the holster/base.

3.Turn off the headset.

4.From the OFF state, press the multi-function button for 10 seconds or until a distinctive three- tone sound will be heard and at the same time the red and blue indicator will alternately blink. This indicates that the headset is now ready for pairing.

5.Press the Menu button. Scroll to Connect., OPTIONS. Choose Open, press SELECT.

Bluetooth, OPTIONS. Open, SELECT. Press button, “Paired devices” will be displayed as title. Press OPTIONS. New paired device, SELECT. “Searching for devices…” will be displayed. Select the headset and press SELECT. “Waiting for…” and “Passcode for…” will be displayed simultaneously.

6.Enter “0000” as the passcode then press OK. “Waiting for…” and “Pairing with…complete” will be displayed simultaneously.

7.Continue pressing Exit key to exit the Menu.

The headset is paired and ready to use. An icon will be displayed during the standby mode indicating that the headset is linked with the phone.

Note: Once paired, press the multi-function button once to establish simultaneous connection between the headset and the phone (keypad tones can be heard on the headset every time the keypad is pressed). If ever the paired device was deleted and turned off, once it is turned on, there is no need to undergo the same pairing procedure. “Passcode for…” will be displayed. Enter the passcode then press OK. “Accept connection request from…” press YES to reconnect.

c.AUTO ACCEPT MODE

The auto accept mode allows the Bluetooth function to be turned on automatically whenever the

user starts sending information such as answering or making a call via the Bluetooth headset.

1.Press the Menu button. Scroll to Connect., OPTIONS. Choose Open, press SELECT.

Bluetooth, OPTIONS. Open, SELECT. Press	button. “Paired devices” will be displayed
as title.

2.Select the headset and press OPTIONS. Scroll to Set as authorised, SELECT. “Connections will take place without confirmation. Continue?” press YES.

3.Continue pressing Exit key to exit the Menu. An icon will then appear on the upper right corner.

d.ANSWERING/RECEIVING A CALL

When the phone is receiving a call, a ring tone will be heard on the headset as well as on the phone.

1.Press the multi-function button down once to answer the call.

2.End the call by pressing the button again.

Note: Cell phone buttons can also be used to answer a call but audio is still transferred to the headset.

e.MAKING A CALL with the headset on

Normal dialing

1.Enter the contact number and send. As you dial, audio and the keypad tones can be heard on the headset simultaneously but not on the phone.

2.Press the multi-function button to hang-up and terminate the call.

Note: If the call is terminated using the cellular phone, a tone will be heard on the headset indicating that the call has been terminated.

Voice dialing

Refer to step g for the procedure when recording for voice dialing.

1.Press the multi-function button once to activate the voice dialing.

2.A beep will then be heard on the headset prompting the user to say the name of the person to call.

3.Say the name. The name will be played back to you. The phone will then place the call automatically. In case the cellular phone does not recognize the name spoken, the steps above may be repeated.