Charging Your Vacuum Cleaner, Assembly

OPERATING INSTRUCTIONS

Charging Your Vacuum Cleaner

1.This cordless vacuum is powered by rechargeable nickel-cadmium batteries. Before using the vacuum, charge the vacuum cleaner for a minimum of 20 hours.

NOTE: Ensure that the On/Off switch is in the “Off” position before charging.

NOTE: Peak performance may only be realized after the unit has been charged and discharged two (2) or three (3) times.

IMPORTANT:To maintain peak performance of your cordless hand vacuum, it is recommended that the unit be fully discharged, then completely re-charged at least once a month.

2.Connect the charging jack to the charging hole that is on the back of the unit.

3.Plug the charger into wall outlet.

4.The charging indicator light

will shine green to indicate that the vacuum cleaner being charged. (Fig. 1)

Assembly

NOTE: Dust cup filter must always be used when operating the hand vacuum.

1.To open the dust cup compartment, push the dust cup release button and remove the dust cup container. (Fig. 2)

2.Verify that the dust cup filter is inside, then re-attach the dust cup container to the hand vacuum. (Fig. 3)

Fig. 2

Fig. 3

3.To attach the crevice tool to the hand vacuum, push the attachment into the suction hole in the front of the dust container. (Fig. 4)

Using Your Cordless Vacuum

1.To start the unit, push the "On/Off" switch to the "On" position.

2.To stop the vacuum cleaner, slide the "On/Off" switch to the "Off" position.

3.A crevice tool is provided for cleaning narrow, hard to reach places.

Using Your Motorized Brush

1.Make sure that the “On/Off” switch is in the "Off“ position.

2.Firmly insert the motorized brush (Fig. 5) into the air-intake nozzle of the dust cup container ensuring that the contact pins are engaged in the connector slots of the unit. (Fig. 6)

NOTE: The motorized brush is for vacuuming short pile carpets or rugs.

Metal

Contact

Pins

Fig. 5

Fig. 6

Changing & Cleaning the Dust Cup Filter

For best performance, empty the dust cup container and clean the dust cup filter after each use.

1.To remove the dust cup container, press down on the dust cup release button and pull off the dust cup container.

2.Pull out the dust cup filter.

3.Empty the dust from the dust cup container. (Fig. 7)

4.Rinse the dust cup filter in cold water, and then wait until it dries completely before replacing it back into the dust cup container. DO NOT use a washing machine to clean the dust cup filter. DO NOT use a hair dryer to dry it. Air dry only.

5.Replace the dust cup filter carefully into the dust cup compartment. NEVER operate vacuum cleaner without dust cup filter in place.

6.Attach the dust cup container to the cordless vacuum.

Fig. 7

NOTE: It is recommended that the dust cup filter be replaced every three

(3)months to ensure peak performance of the unit.

Fig. 1

Fig. 4

WARNING: DO NOT touch the motorized brush while it is in motion.

CAUTION: The suction hole must be open and free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged.

WARNING: NEVER use ordinary batteries for replacement, as these may leak and damage your vacuum cleaner.