HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the bag, belt, and brush roll often.
Brush Roll
The brush roll turns to brush and sweep the carpet. Remove hair and threads from the brush roll so it can continue to brush the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length, hold a ruler against the underneath side of the cleaner. If the bristles no longer touch the ruler, replace the brush roll.
Brush Roll Belt
Pull | Pull |
The brush roll belt turns the brush roll as the bristles sweep and brush the carpet. Check the belt regularly to be sure it is in good condition. Replace the belt if it stretches, cracks or loses tension. Cut away any hair or threads wound around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly.
How to Replace Brush Roll Belt
NOTE: Turn off the switch and unplug the electrical cord before replacing belt. Belt pulleys can become hot during normal use. To prevent injury, avoid touching the motor pulley when checking the belt.
CAUTION: Improper installation of the brush roll could cause carpet or cleaner damage.
1.Turn the cleaner over. Pull up to remove bottom plate.
2.Lift out brush roll and discard old belt.
3.Fold new belt to slide it around the motor pulley.
4.Place belt around pulley end of brush roll.
5.Pull left end of brush roll down to stretch belt. Align the end cap with the base and push down to secure.
6.Seat right end cap.
7.Turn the brush roll until the belt centers onto the brush roll pulley.
8.Slant front of bottom plate to catch tabs into cleaner slots. Push down above each hook to snap into place.
Use GENUINE EUREKA replacement belt, 54312.
GENUINE
Look for the EUREKA PRODUCT symbol.
Tabs
For location of nearest Eureka Warranty Station or service information call
Motor
Pulley
p | p |
p | p |
Slots 
7