How to Wall Mount your Wall Bracket
CAUTION: Use only charger model A7400 for 120 volt; model
Your vacuum cleaner has a special bracket designed | Holes for |
to hold the unit, so that it may recharge while mounted | |
on the wall. | Screws. |
Cleaner hangs in bracket with the nozzle end down. |
|
Mount on a wall where there are no dangerous objects |
|
hidden beneath the wall surface like electrical wires, |
|
pipes, etc. |
|
1.Hold bracket against wall to mark location for screws. Make sure the wall bracket is positioned vertically, with the charger socket at the bottom.
2.Use a 1/4 inch drill for drilling holes for the plastic anchors.
3.Insert the anchors. Line up the bracket with the anchors.
4. Use a screwdriver to drive the screws into the anchors to secure the bracket.
How to Mount your Vacuum Cleaner
5.Rest the cleaner on the docking pegs, with the nozzle pointed down push on the unit until you hear the charger socket click into place.
6.Plug the charger into an electrical outlet.
Docking
Pegs
Charger
Socket
Charger
Plug
NOTE: Charge the cleaner for
How to Switch Optional Charger Plug
1.Remove the screw in the middle of the back of the wall bracket and remove back cover.
2.Unwind the cord from cord holders and pull charger socket up and away from wall bracket.
3.Insert new charger socket into charger socket hole and wind cord around cord holders.
4.Replace back cover lining cord up with notch in back cover. Replace screw.
Charger
Socket
Hole
Cord
Holders
Keeping your Vacuum Cleaner Ready for Use
Return your vacuum cleaner to the wall holder after every use. Firmly position into the mounting bracket ensuring that the vacuum cleaner fits correctly into the charging socket. It will then be recharged and ready for operation at all times.
The charger plug can be left in the electrical outlet at all times, even when the unit is in use. It is impossible to overcharge the batteries. The charger plug will become warm, however, this is not a cause for concern.
6