SATO M84PRO service manual Error Signals, LED LCD Message Beep Error Condition To Clear

TROUBLESHOOTING 6

ERROR SIGNALS

The LED display, Front Panel LED Indicators and Buzzer provide a visual and audio indication of the type of error encountered. Find the correct symptom in the table below to reference the correct response.

LED			LCD MESSAGE	BEEP	ERROR CONDITION	TO CLEAR
Error on			Machine error	1 long	Machine Error	Cycle power on/off.
Error on			EEPROM error	1 long	EEPROM read/write error	Cycle power on/off.
Error on			Head error	1 long	Print Head is damaged	Replace	print	head.
						Cycle power.
Error on			Sensor error	3 short	Sensor	Cycle power on/off.
Error blinks			Card r/w error	1 long	Memory card read/write	Format	card and	cycle
						power.
Error blinks			Card low Battery	1 long	Memory card battery low	Replace	battery	and
						cycle power.
Error blinks			Head Open	3 short	Head open	Latch print head.
Error	on	Line	Parity Error	3 short	RS232 parity error	Match parity to system.
blinks
Error	on	Line	Overrun Error	3 short	RS232 overrun error	Verify RS232 settings.
blinks
Error	on	Line	Framing Error	3 short	RS232 framing error	Verify RS232 settings
blinks
Error	on	Line	Buffer Over	3 short	Buffer overflow	Verify RS232 settings.
blinks
Error	on	Line	Paper End	3 short	Media end or misselected	Replenish media, select
blinks					media type.	correct	media,	open/
						close head lever, open/
						close media hold down
Error	blinks		Ribbon End	3 short	Ribbon end or ribbon broken.	Replace	ribbon.	Open/
Ribbon on						Close Head Lever.
						Open/Close Media Hold
						Down
Error	blinks,		Media Error	3 short	Media error	Open/Close head lever.
Label blinks
Ribbon blinks				None	Ribbon near end.	Replace ribbon with full
						roll.
Line blinks				None	Buffer near full	Slow down transmission
						rate.

M84Pro Service Manual PN: 9001111A Page 6-1