SATO M84PRO Clear Dispenser Counter, Press the Feed key to clear the dispenser counter

Section 9: Factory Resets

11 Press the FEED key to test print. Press the FEED key again to stop printing.

WARNING: THIS TEST ACTIVATES ALL THE HEATING ELEMENTS ON

THE PRINT HEAD AND THEREFORE SHOULD BE USED FOR TESTING

PURPOSES ONLY. FULL WIDTH LABELS MUST BE USED TO PREVENT

PRINT HEAD DAMAGE.

12Verify that the counters on the test print have reset to 0.0 km.

13Power Off the printer and confirm that all switches are in the Off or down position.

CLEAR DISPENSER COUNTER

CAUTION: RESETTING THE PRINTER WILL CLEAR ALL REGISTERS.

1 Record all dip switch positions.
2	Place all dip switches in the OFF position.
3	Place the DSW2-4 in the ON position.
4	Simultaneously, press and hold the LINE and FEED keys while turning on the power switch.
5	Release the LINE and FEED keys upon hearing a beep.
		LCD DISPLAY:	INITIALIZING ROM V00.00.00.00
			MAINTENANCE MODE DIPSW2-4 ON->OFF
6	Place the DSW2-4 in the Off position.
		LCD DISPLAY:	FACTORY MODE
7	Press the FEED key to display the next screen.
		LCD DISPLAY:	COUNTER CLEAR - NONE
8	Press the LINE key twice to change the message from NONE to DIS.
		LCD DISPLAY:	COUNTER CLEAR - DIS
9	Press the FEED key to clear the dispenser counter.
		LCD DISPLAY:	PRINT SIZE
			SMALL	LARGE
10 Select the print label size by pressing the LINE key.
		NOTE: The default selection is large. The LINE key allows scrolling from one
		option to another.
11	Press the FEED key to test print. Press the FEED key again to stop printing.

M84Pro Service Manual PN 9001111A Page 9-3