SATO M84PRO service manual Interface Board Replacement

Section 7: Replacement Procedures

INTERFACE BOARD REPLACEMENT

1Switch off the printer and disconnect the power supply cord.

2Open/remove the top, right, and left housing covers.

NOTE: Figure 10-1 of the Daigrams & Schematics section provides guidance on housing cover removal.

3Remove two screws (1, Figure 7-3) securing interface board (2) on the exterior back side of printer.

4Carefully withdraw interface board (2) from its connection with main circuit board (3).

5Insert replacement interface board (2) through the housing slot to connect with main circuit board (3).

6Secure interface board (2) to printer housing using two screws (1).

7Reconnect power supply cord, test cycle, and reattach left side cover.

NOTE: Figure 10-1 of the Daigrams & Schematics section provides guidance on housing cover installation.

2

3

1

Figure 7-3, Interface Board Replacement

M84Pro Service Manual PN: 9001111A Page 7-3