Section 5: Printer Configuration
LCD DISPLAY |
| DEFINITION | |
|
| ||
PITCH OFFSET | The label Pitch is the distance from the leading edge (the edge that comes out | ||
| + 00mm | of the printer first) of a label and the leading edge of the next label. The | |
|
| leading edge position of the label can be adjusted relative to the print head +/- | |
|
| 49 mm in increments of 1mm. Once the position is set, it can be fine adjusted | |
|
| +/- 3.75 mm using the PITCH potentometer. | |
|
| 1. | The cursor will initially be positioned over the Pitch Direction setting. Use |
|
|
| the LINE key to step to the positive (+) or negative |
|
|
| selection moves the leading edge of the label forward (away from the print |
|
|
| head) while a negative selection moves the leading edge of the label back |
|
|
| into the mechanism. |
|
| 2. | Press the FEED key to select the option and advance the cursor to the |
|
|
| Offset selection. |
|
| 3. | Use the CURSOR keys to step the first digit of the counter to the desired |
|
|
| option. The display will increment one step each time the Cursor keys are |
|
|
| pressed. The maximum setting is 5. |
|
| 4. | Press the FEED key to select the option and advance the cursor to the |
|
|
| second digit. Again use the CURSOR keys to step to the desired option. |
|
| 5. | Press the FEED key to select the option and advance to the next display |
|
| 6. | Print a test label after completing the adjustments to ensure they are |
|
|
| correct. |
|
| ||
CANCEL PRINT JOB | Selecting the YES option will cause all print jobs to be cleared and not | ||
YES | NO | recovered. The default option is NO. | |
|
| 1. | Use the Cursor keys to step the cursor to either the YES or NO option. |
|
| 2. | Press the ENTER key to select the option and advance to the next display |
|
| ||
CANCEL PRINT JOB | The printer will beep 3 times and the display will appear for 3 seconds before | ||
COMPLETED | returning to the initial | ||
|
| The printer must be taken | |
|
| change any of the settings. | |
|
|
|
|
ADVANCED MODE
An Advanced Mode is provided to make adjustments that require only occasional changes. Since they affect the basic operation of the printer, the procedure for entering this mode is designed to prevent someone from accidently changing the settings.
| LCD DISPLAY | DEFINITION |
|
| |
V 05.00.03.00 | Displays the firmware during the initialization. | |
| INITIALIZING |
|
ADVANCED MODE | Press and hold the LINE key while switching the power switch On. Release | |
|
| the LINE key when the printer emits one long beep. Press FEED. |
|
| |
DARKNESS RANGE | This setting allows the selection of darkness ranges. Option B is the darker | |
A | B | image of the two. Use the LINE key to move the cursor to the desired option |
|
| and press the FEED key to select. |
|
|
|
M84Pro Service Manual | PN 9001111A | Page |