SATO M84PRO service manual 2a, Dispenser Installation

Section 4: Accessories Installation

NOTE: Figures 10-1, 10-2, and 10-3 in the Diagrams & Schematics section provide guidance on housing cover, media, and ribbon removal respectively.

3Remove the ribbon and label stock if applicable and leave the print head open.

4Remove screw (1, Figure 4-2a) securing front cover (2) to the printer frame. Lift away front cover (2).

NOTE: The screws are accessible at the rear of the cover on the right side.

Manipulate the cover upward and outward to remove.

2

1

Figure 4-2a, Dispenser Installation

5 Route dispenser wiring harness (3) through the slot in the printer side wall.

CAUTION: WHEN ROUTING THE WIRING HARNESS, ENSURE THAT IIS

ROUTED IN A MANNER SO AS TO PREVENT PINCHING OR

INTANGLEMENTS.

M84Pro Service Manual PN: 9001111A Page 4-5